Batteries

Check Battery on JBL Wonderboom 3

Gives the Check Battery on JBL Wonderboom 3 methods, and also, how to tell if the battery is losing capacity over time.  When you press the right buttons while the speaker is running, it emits one or more sound pulses to tell you how full the battery is, as described below.

Check Battery on JBL Wonderboom 3: Step by Step

1. First, Power Up the JBL Wonderboom 3

You won’t be able to read battery unless the speaker is ON.

Top view of the JBL Wonderboom 3. Showing the dark -Power- button.

To turn on the speaker, press and release the Power button, pointed out by the yellow arrow the last picture.

The small lamp in that button should then light, as we see next, and the speaker should make its startup sound.  If it does not, then the battery could be completely dead.

The glowing -Power- button.

But as long as there’s some energy in the battery, the speaker should boot.  When it does, move ahead to the next step.

2. Press and Release the Volume UP and Volume DOWN Buttons

Press and release the center areas of the Volume UP and Volume DOWN buttons at the same time.  Find these areas in the picture shown next. The Volume Up button is in the center of the plus (+) symbol on the speaker front, and the Volume Down button is found in the middle of the vertical minus (-) symbol, just below the plus symbol.

The -Volume UP- and -Volume DOWN- buttons on the JBL Wonderboom 3.

When you press these buttons together, the speaker makes one to four “blunk” sounds to tell you how high the battery is.  Four blunks means that the battery has between 75 and 100 percent charge.  Three blunks, and the battery has between 50 and 75 percent charge.  Two blunks denotes that you have between 25 and 50 percent charge in the speaker’s battery.  And finally, one blunk means between 0 and 25 percent charge.

Now since the JBL Wonderboom 3 plays for up to fourteen (14) hours on a full charge, you can estimate based on the number of blunks you get, approximately how much play time you have left.  Four blunks means that you have between 10.5 and 14 hours left.  Three blunks means between 7 and 10.5 hours. Two blunks means between 3.5 and 7 hours. And one blunk means that you have less than 3.5 hours of playing time to go before the speaker dies.

Other JBL Wonderboom 3 Posts

    1. Flashing White Light
    2. Won’t Turn ON or Charge
    3. How to Connect To This Model
    4. How to Make Discoverable
    5. The Panel Buttons Explained

References

    1. Official JBL Wonderboom 3 Support Page
    2. Where to Buy the JBL Wonderboom 3
admin

Recent Posts

Fix DVD Skips and Freezes

We have nearly three decades experience playing and caring for digital video discs (DVDs). Indeed,…

4 hours ago

Telling That JBL Charge 3 is Charging

Lists ways of Telling That JBL Charge 3 is Charging. Now this BT speaker with…

4 hours ago

Reboot Samsung Galaxy J7

In this piece, we cover the Reboot Samsung Galaxy J7 procedure. You might do this…

4 hours ago

JBL Xtreme 2 Firmware Update

Here, we offer JBL Xtreme 2 firmware update procedure for this revised version of the…

6 hours ago

Echo Dot 2 Buttons

The Echo Dot 2 features several buttons and a light ring around its top, and…

7 hours ago

Sony SRS XG300 Power Button Not Working Fix

Here are some fix ideas for when you find the Sony SRS XG300 Power Button…

7 hours ago