Covers How Long Does a UE Wonderboom 2 Take to Charge. Use the hidden micro USB charge port on the back of the unit, near the bottom. So here, we run through the charge procedure.
In short, first select a powerful enough USB power adapter. Why? Because Logitech does not include this with the UE Wonderboom 2 as a standard accessory. But you can buy one from them for roughly $20 US if you wish.
Then, connect a micro USB charge cord between the WB and that adapter. Then, plug that power supply into a working AC receptacle.
Finally after a few hours, your UE Wonderboom 2 fully recharges. Then you can play it again for perhaps ten hours before it needs another charge.
First of all, we charge the WB with the iClever 24 watt dual port USB charger adapter, as shown next. The speaker needs 5 volts at approximately 0.6 amps to charge fully in a reasonable amount of time. So this iClever USB wall adapter is indeed strong enough to recharge the unit with lots of energy to spare.
Second, use a penny or a dime to pry open the waterproof seal port cover on the WB. This reveals the micro USB charging port inside, as shown next.
Next, note that the WB still charges when running. But depending on your charger, it may recharge slightly faster when turned OFF.
Then, plug the small end of your micro USB charge cable into the matching micro USB port. Find the port in the rear of this unit.
Then, connect the A end of the USB charge cable to the power adapter. Furthermore, in this demo, we use an iClever 24 Watt 2.1 amp per port USB power adapter. We also supply our own generic micro USB cable.
The status lamp in the power button lights a fading and brightening white pattern when you supply enough USB power. While no battery status gauge shows percentage of charge, the pulsating white lamp means that charging is happening. Then when the speaker is OFF, it goes out when charging completes. If the WB is ON, this lamp starts glowing a solid white.
Battery charging is complete when the gradually brightening and fading power lamp stops pulsating.
Note that unless you snap this port door tightly into place, water could enter this area. Then this might damage the electronics inside the UE Wonderboom 2. So, be sure to press door closed with firm force to seat it, for full water resistance.
Finally, we have now fully charged this Bluetooth speaker.
At last, for best battery performance, repeat this recharging every ten hours of play time. This keeps the battery in top working order for months to come. Further, don’t let the battery stay dead for very long. Why? Because if it remains dead for too long, it can stay that way even when you try to recharge it.
How Do You Tell That JBL Flip 3 is Charging? Well, this Bluetooth speaker sports…
Here, we give the Remove Temporary Hold on Honeywell Thermostat procedure. Now this begs the…
The most "meaty" part of installing a new Honeywell WiFi thermostat, is correctly wiring it…
Temperature differential is the difference between the turn-on and turn-off temperatures on a thermostat, whether…
Here, we give the Cancel Hold on Honeywell Thermostat procedure. But why would hold ever…
You might need to know How to Connect Honeywell WiFi Thermostat to Network for the…