How Long Does Logitech Wonderboom 3 Take to Charge

Top view of the Wonderboom 3 speaker. showing the glowing Power button.

Answers the How Long Does Logitech Wonderboom 3 Take to Charge question, by detailing the fastest procedure. Now charging is easy through the sealed micro USB DC in port on the rear bottom of the speaker. First, pick a high current USB AC adapter. Why? Because you do not get this with the Logitech Wonderboom 3. But the company does offer one that works well for less than twenty US dollars.

Next, connect a micro USB charge cord between the Logitech Wonderboom 3 and that adapter. Then, plug that power supply into a working AC mains outlet.

Finally after roughly three hours, the speaker fully recharges. Then, you can play it again for around thirteen hours before it runs dead again.

How Long Does Logitech Wonderboom 3 Take to Charge: Step by Step

1. Choose Strong Enough USB Charger

In this demo, we’re using the iClever 24 watt AC USB charger, as shown next. The Logitech Wonderboom 3 needs 5 volts at about 1.0 amp to charge fully in the shortest time. So this iClever USB wall adapter is indeed strong enough for the job.

iClever IC-TC02 Two Port USB Wall Charger, showing the label side view.

2. Open the Power Port Cover Door

Use a dime or penny to open the waterproof seal port cover. This uncovers the micro USB charging port inside, as shown next.

The Logitech Wonderboom 3 back view, with door open. Showing the micro USB charging port.

3. Power Off the Unit, to Continue Answering How Long Does Logitech Wonderboom 3 Take to Charge

Note that the speaker still charges when running. But depending on your charger, it may recharge a little faster when turned OFF.

Top view of the Logitech Wonderboom 3. showing the glowing Power button.

4. Plug in the Micro USB Cord

Then, plug the small end of your micro USB charge cable into the matching micro USB port.

5. Plug the Other End of the USB Cord into the AC Wall Adapter

Next, connect the A end of the USB charge cable to the power adapter. In this demo, as we said earlier, we use an iClever 24 Watt 2.1 amp per port USB power adapter along with a generic micro USB cable.

6. Plug the AC USB Power Adapter into a Wall Outlet to Continue Answering How Long Does Logitech Wonderboom 3 Take to Charge

Now that we connected the speaker and charger, we plug the charger into a working AC outlet.

The status light in the power button lights a fading and brightening white pattern on this BT speaker with enough USB power. While no battery status gauge shows charge percentage, the pulsating white lamp means that charging is happening.

Then when the speaker is OFF, this lamp goes out when charging finishes If the speaker is ON, this lamp starts glowing a solid white once more.

7. Let the Logitech Wonderboom 3 Charge Until the the Power Lamp Stops Pulsating

Battery charging is finished when the gradually brightening and fading power lamp stops pulsating. Detail: when the speaker is OFF, this lamp goes out when charging finishes But if the speaker is ON, the light starts glowing a solid white once more.

8. Unplug the USB Cord

9. Close the USB Port Door

Note that unless you snap this door tightly into place, water might get inside, and too much moisture could damage speaker electronics in there. So, be sure to press the door closed with enough pressure to fully seat it, to help ensure full water resistance.