This piece covers how to charge the Sony X11 Bluetooth cube speaker. Do this easily through the micro USB power in port, shown in the pictures below. Note that you can still play your X11 as it charges, without increasing the recharge time by much.
First, pick a strong enough USB power adapter, as no charger comes with the Sony X11. Next, connect a medium to high current USB cable between the speaker and that adapter (the speaker comes with a short micro USB to USB-A cord). Then, plug the charger into a working wall outlet. Finally, after four hours or so, your X11 finishes recharging. So it’s ready to play once more for up to twelve (12) hours before needing another recharge.
The charger you use should provide 5 volts and at least 0.5 amps (2.5 watts). This option though yields much longer charging times. But ideally, you want a 1.5 amp charger (7.5 watts) for the fastest recharging. So here, we use a Key Power model HDD15-3-PD USB power delivery system. Now as mentioned, this speaker needs roughly an amp and a half current to recharge fully in a reasonably short time. So this charger supplies way more than enough power to do the job.
Note that the SRSX11 still charges when powered ON. But depending on how much above-and-beyond recharging capacity your charger supplies, the speaker might charge a little faster when turned OFF.
Then, plug the small end of the cable into the port on the back of the speaker, as we see in the next shot.
Next, connect the large end of the cord to the AC or car adapter.
Now that we connected the X11 and our adapter, we then plug the mains end of the adapter into a working AC outlet, as shown next. We plugged ours into a surge protecting power strip.
The status lamp lights up solid orange on the speaker. And while no battery status gauge shows percentage of charge, the glowing CHARGE lamp means that charging is occurring, as shown next.
Full battery charging is complete when the solid glowing status lamp near the bottom of the speaker turns off, as shown next.
We have now fully charged this Sony cube speaker.
Finally, repeat this recharging every twelve hours of play, to keep the battery in top condition for years.
This piece covers Troubleshooting Honeywell Thermostat Not Reaching Set Temperature problems and how to solve…
In this piece, we show ways for Finding Internet Radio Stream URL. You may own…
Here, we show how to factory reset a Wonderboom to put it back to its…
Gives the connect Logitech Wonderboom to iPhone procedure. Now this can also work with other…
This post gives the Alexa Dot Bluetooth Pairing procedure. These directions include the all Bluetooth…
You can reset all of the smart speakers in the Google Home family. These include…