How to Charge Sony XB22

This piece covers how to charge the Sony XB22 BT speaker. Do this easily through the micro USB power in port, shown in the pictures below. Note that you can still play your XB22 as it recharges, without raising the charging time by a whole lot.

First, pick a powerful enough USB adapter, as no charger comes with this particular Sony BT speaker.  Next, connect a medium to high current USB cable (one that easily handles 1.5 amps) between the speaker and that adapter (the speaker comes with a suitable but short micro USB to USB-A cord). Then, plug the charger into a working wall outlet. Finally, after four hours or so, your XB 22 finishes recharging.  So it’s ready to play once more for up to twelve (12) hours before needing another charge-up.

How to Charge Sony XB22, Step by Step

1. Choose Correct Size AC or Car Adapter

The charger you use should provide 5 volts and at least 0.5 amps (2.5 watts). But for fastest results, use one that can deliver 5 volts at 1.5 amps (7.5 watts). So with that in mind, we use here the Key Power model HDD15-3-PD USB charger station.  Now as we said earlier, this speaker needs roughly one and a half amps of current to recharge fully in the shortest time.  Thus, we chose this charger, because it supplies way more than enough capacity for this job.  Now you could use a small charger (0.5 amp), but this would increase the recharge time to more than ten (10) hours. Thus, we choose the higher current option.

2. Power OFF the Unit (Optional)

Note that the SRSXB22 still charges when running.  But depending on how much above-and-beyond recharging headroom that your charger supplies, the speaker might charge a trifle faster when turned OFF.

3. Plug the Micro USB Cord into the XB22

First, open the water resistant port door.

This exposes the micro USB input port as we see next.

Then, plug the small end of the cable into the port on the back of the speaker, as we see in the next shot.

4. Plug the Other End of the Cable into your Charger Adapter to Continue with How to Charge Sony XB22

Next, connect the large end of the cord to the AC or car adapter.

5. Plug the USB Adapter into a Working Wall Receptacle

Now that we connected the XB 22 and our adapter, we then plug the mains end of the adapter into a working AC outlet, as we show next. We connected ours to a power strip surge protector.

The status lamp lights up solid orange on the speaker. And while no battery status gauge shows percentage of charge, the glowing CHARGE lamp means that charging is occurring, as shown next.

6. Let the XB22 Charge Until the Orange CHARGE Light Goes Out

Full battery charging is complete when the solid glowing CHARGE lamp on the top panel, behind the Power button turns off, as shown next.

7. Unplug the Micro USB Cord

Also, close the port cap to maintain water resistance.

8. Done with How to Charge Sony XB22 !

We have now fully charged this Sony Bluetooth speaker.

Finally, repeat this recharging every twelve hours of play, or any time the 2`2 goes dead, to keep the battery in top condition for years to come.

Other Sony XB22 Posts

1. 1. Sony XB22 Blinking Orange Light
   2. How to Connect Sony XB22 to iPhone
   3. Sony XB22 Specs Watts
   4. Sony XB22 Power Button Not Working
   5. Sony XB22 Pairing Instructions

References

1. 1. Official Sony XB22 Support Page
   2. Where to Buy the Sony XB22