Batteries

How to Check Battery Level on JBL Wonderboom 3

Shows how to check battery level on JBL Wonderboom 3, and also, how to tell if the battery is losing capacity over time.  When you press the right buttons while the speaker is running, it emits one or more sound pulses to tell you how full the battery is, as described below.

How to Check Battery Level on JBL Wonderboom 3: Step by Step

1. First, Power Up the JBL Wonderboom 3

You won’t be able to read battery unless the speaker is ON.

Top view of the JBL Wonderboom 3. Showing the dark -Power- button.

To turn on the speaker, press and release the Power button, pointed out by the yellow arrow the last picture.

The small lamp in that button should then light, as we see next, and the speaker should make its startup sound.  If it does not, then the battery could be completely dead.

The glowing -Power- button.

But as long as there’s some energy in the battery, the speaker should boot.  When it does, move ahead to the next step.

2. Press and Release the Volume UP and Volume DOWN Buttons to Continue with How to Check Battery Level on JBL Wonderboom 3

Press and release the center areas of the Volume UP and Volume DOWN buttons at the same time.  Find these areas in the picture shown next. The Volume Up button is in the center of the plus (+) symbol on the speaker front, and the Volume Down button is found in the middle of the vertical minus (-) symbol, just below the plus symbol.

The -Volume UP- and -Volume DOWN- buttons on the JBL Wonderboom 3. Press these buttons to hear an audio signal that indicates battery level.

When you press these buttons together, the speaker makes one to four “blunk” sounds to tell you how high the battery is.  Four blunks means that the battery has between 75 and 100 percent charge.  Three blunks, and the battery has between 50 and 75 percent charge.  Two blunks denotes that you have between 25 and 50 percent charge in the speaker’s battery.  And finally, one blunk means between 0 and 25 percent charge.

Now since the JBL Wonderboom 3 plays for up to fourteen (14) hours on a full charge, you can estimate based on the number of blunks you get, approximately how much play time you have left.  Four blunks means that you have between 10.5 and 14 hours left.  Three blunks means between 7 and 10.5 hours. Two blunks means between 3.5 and 7 hours. And one blunk means that you have less than 3.5 hours of playing time to go before the speaker dies.

Other JBL Wonderboom 3 Posts

    1. Adjust Volume on
    2. Buttons Guide
    3. How to Adjust Volume on
    4. Connect to iPhone
    5. How to Reset a

References for How to Check Battery Level on JBL Wonderboom 3

    1. Official JBL Wonderboom 3 Support Page
    2. Where to Buy the JBL Wonderboom 3
admin

Recent Posts

Instructions for Spotify Setup on Amazon Echo Alexa

If you're a Spotify streaming service subscription holder, you can now listen to your playlists…

14 hours ago

Unlink Spotify From Google Home Speaker

Here, we cover Unlink Spotify From Google Home Speaker.  You may wish unlink (remove, delete)…

14 hours ago

Reset Alexa Echo Spot

You might reset Alexa Echo Spot and return the settings to their factory default values,…

16 hours ago

How to Find Echo Spot IP Address Setting

In this post, we run through how to find the Echo Spot IP address setting,…

16 hours ago

Reset Echo Spot WiFi

You might reset Echo Spot WiFi to fix faulty connection behavior, put it on a…

16 hours ago

Echo Spot Firmware Update

Here, we detail our Echo Spot firmware update procedure for the Amazon Alexa Echo Spot.…

18 hours ago