Batteries

How to Check Battery Level on Logitech Wonderboom 3

Shows how to check battery level on Logitech Wonderboom 3, and also, how to tell if the battery is losing capacity over time.  When you press the right buttons while the speaker is running, it emits one or more sound pulses to tell you how full the battery is, as described below.

How to Check Battery Level on Logitech Wonderboom 3: Step by Step

1. First, Power Up the Logitech Wonderboom 3

You won’t be able to read battery unless the speaker is ON.

Top view of the Logitech Wonderboom 3. Showing the dark -Power- button.

To turn on the speaker, press and release the Power button, pointed out by the yellow arrow the last picture.

The small lamp in that button should then light, as we see next, and the speaker should make its startup sound.  If it does not, then the battery could be completely dead.

The glowing -Power- button.

But as long as there’s some energy in the battery, the speaker should boot.  When it does, move ahead to the next step.

2. Press and Release the Volume UP and Volume DOWN Buttons to Continue with How to Check Battery Level on Logitech Wonderboom 3

Press and release the center areas of the Volume UP and Volume DOWN buttons at the same time.  Find these areas in the picture shown next. The Volume Up button is in the center of the plus (+) symbol on the speaker front, and the Volume Down button is found in the middle of the vertical minus (-) symbol, just below the plus symbol.

The -Volume UP- and -Volume DOWN- buttons on the Logitech Wonderboom 3. Press these buttons to hear an audio signal that indicates battery level.

When you press these buttons together, the speaker makes one to four “blunk” sounds to tell you how high the battery is.  Four blunks means that the battery has between 75 and 100 percent charge.  Three blunks, and the battery has between 50 and 75 percent charge.  Two blunks denotes that you have between 25 and 50 percent charge in the speaker’s battery.  And finally, one blunk means between 0 and 25 percent charge.

Now since the Logitech Wonderboom 3 plays for up to fourteen (14) hours on a full charge, you can estimate based on the number of blunks you get, approximately how much play time you have left.  Four blunks means that you have between 10.5 and 14 hours left.  Three blunks means between 7 and 10.5 hours. Two blunks means between 3.5 and 7 hours. And one blunk means that you have less than 3.5 hours of playing time to go before the speaker dies.

Other Logitech Wonderboom 3 Posts

    1. How Do I Know When This Speaker Is Fully Charged
    2. How to Make Discoverable
    3. No Firmware Update
    4. The Buttons Guide
    5. Fixing the Won’t Turn ON Problem

References for How to Check Battery Level on Logitech Wonderboom 3

    1. Official Logitech Wonderboom 3 Support Page
    2. Where to Buy the Logitech Wonderboom 3
admin

Recent Posts

Factory Reset Google Home Mini Speaker

Here we cover the Factory Reset Google Home Mini Speaker procedure. Now you might factory…

48 mins ago

Factory Reset Google Home Mini

Here we cover the Factory Reset Google Home Mini procedure. Now you might factory reset…

56 mins ago

How to Reboot Samsung Galaxy J7 Sky Pro Tracfone

In this piece, we run though How to Reboot Samsung Galaxy J7 Sky Pro Tracfone.…

1 hour ago

How to Install SD Card in Samsung Galaxy J7 Tracfone

You can add up to 128 GB more internal storage (memory) to your Samsung J7…

2 hours ago

How to Turn OFF Tracfone J7 Samsung Sky Pro Galaxy

In this piece, we demonstrate How to Turn OFF Tracfone J7 Samsung Sky Pro Galaxy…

3 hours ago

Turn Off Samsung J7

In this piece, we give the Turn Off Samsung J7 procedure for this Galaxy phone. …

3 hours ago