The Sony SRS XB13 speaker charging.
Covers how to check battery life and level on the Sony Extra Bass XB 13 Bluetooth speaker, and also, how to know if the battery life is gradually growing shorter over time.
You won’t be able to read battery charge status unless the speaker is ON.
To turn on the speaker, press and release the Power button, pointed at by the green arrow in the last picture. It’s the button farthest to the left on the button panel.
The little lamp right above the Power button should then light up green, as shown next, and the speaker may make a two-beep sound if it pairs to a nearby device. If it does not turn on, then the battery could be completely dead.
But as long as there’s some juice in the battery, the speaker should power up. Then when it does, move ahead to the next step.
Note that this speaker has no battery gauge to communicate exactly how much charge it has left. But you can at least, tell if the battery is on the verge of going dead by way of the CHARGE lamp. When the battery is not critically low, this lamp is dark when the speaker is running. But when the speaker has very little charge left, the CHARGE lamp flashes orange during play.
E.g. The next picture shows the lamp location, just below and to the left of the Power button.
When the speaker is new, and using a full power USB charger, the battery charge time is about four and a half (4.5) hours to reach a full charge.
And, the fully charged battery should last for around sixteen (16) hours of play time before going dead, when played at moderate volume levels, five (5) playing hours when you listen at full volume.
A sign of a bad battery, is that it goes dead too fast, or takes too little or too much time to fully charge. So if you fully charge your speaker, but it only plays for under twelve hours before dying, its battery may be headed toward badness, and unable to hold a full charge anymore.
If the XB 13 battery takes longer than six hours to completely recharge, this could also mean a failing battery. It might mean also, that the charger you’re using is not hefty enough to recharge the speaker in the specified charge time of 4.5 hours. Test this by using a different but known-good charger.
Also, elongated charging might happen because your charge lead is too thin. So for best results, we recommend a full-current USB cord (one that easily carries 2.1 amps).
Here, we show how to update JBL Charge 3 speaker firmware for this popular Bluetooth…
We received the Waterpik NSP-853 Power Spray Plus massaging shower head for Christmas some years…
All smart speakers in the Google Home family now support Bluetooth. They can act as…
Firstly, the original Google Home speaker has a sleep timer that you can set and…
Follow these JBL Flip 4 speaker charging instructions for longest play using the hidden USB…
Here, we list JBL Flip 4 speaker specs specifications. To summarize, these cover the speaker's…