Picture of the front of the Sony SRS XE300 speaker.

How to Hard Reset Sony SRS XE300

Show you how to hard reset your Sony SRS XE300 portable BT speaker to its default settings. Hard resetting restores the XE300 to factory default state. Plus, doing this erases any earlier paired Bluetooth devices from memory. We might want to clear these to prevent this speaker from pairing to any nearby Bluetooth devices. Also, you would best reset the unit to get it ready for sale or re-gifting, or to stop it from pairing with devices you no longer wish it to connect with.

How to Hard Reset the Sony SRS XE300, Step by Step

1. Turn ON the Speaker

Press and release the Power button for a half-second or so. Find this button as we show in the next picture.

 

Picture of the Power button on the Sony SRS XE300 speaker.
The Power button on the Sony SRS XE300 speaker.

Then, the status light comes on, as we see next.  This light we find just to the left of the Power button near the top of the speaker on the buttons panel.

Picture of the green glowing power lamp on the Sony SRS XE300 speaker.
The green glowing power lamp on the Sony SRS XE300 speaker.

The speaker makes a rising electronic sound when it powers up, whether it connects to a nearby device or not. But whether it pairs or not, this reset routine works the same, as follows.

2. Press and Hold the Volume DOWN and Pairing Buttons

Both of these buttons we find on the panel in the back of the speaker, as called out in the next picture. Counting from the top, the Pairing button is the second button down from the top, just below the Power button.  And, the Volume Down button is the fifth one down from the top, just below the Volume UP (+) button, and just above the BATT button.

Picture of the Pairing and Volume Down buttons.
The Pairing and Volume Down buttons.

Then, hold both buttons in until all lamps go out, the unit plays a power-off sound, and then the speaker shuts down completely.  This takes around five seconds as the speaker hard resets.





Next, the speaker powers OFF, and the Power and Pairing lamps go dark, as shown next.

Picture of all dark lamps on the Sony SRS XE300 speaker.
All lamps are dark here on the Sony SRS XE300 speaker.

You may release the buttons when all the lights go dark.

3. Check that your Sony SRS XE300 Speaker Did Indeed Hard Reset

Next, power on the XE 200 once more, as described in step 1 above.

Note that after a hard reset, this speaker comes up in pairing mode. The Pairing lamp blinks in a pulse-pulse-pause, pulse-pulse-pause pattern to tell you this.  This is a signal for you to look for this speaker on a nearby BT device, and pair to it if you so desire.

4. Done with How to Hard Reset the Sony SRS XE300 !

The hard reset is now complete. So you may now sell or gift the unit, or pair it again with your favorite Bluetooth devices.

After a hard reset, the speaker no longer automatically connects with any previously paired device. Thus, to restore this auto syncing, you manually pair the XE300 with a device. Then after that, any time that both speaker and that device have Bluetooth ON, and they’re near to each other, pairing would automatically take place once more.

Other Posts About the Sony SRS XE300

    1. How to Connect Sony SRS XE300 to iPhone

Related Posts to How to Hard Reset Sony SRS XE300

    1. Sony SRS XE200 BT Speaker How to Hard Reset
    2. How to Hard Reset Sony SRS XB40 Speaker
    3. Hard Resetting the Sony SRS X3 BT Speaker
    4. How to Hard Reset Sony SRS X2 Portable Speaker
    5. JBL Charge Bluetooth Speaker How to Hard Reset

References for How to Hard Reset Sony SRS XE300

    1. Official Product Page for the Sony SRS XE300 Speaker at Sony.com

Revision History

    • 2022-09-22: First published.
%d bloggers like this: