Top front view of the Sony SRS XB12 Extra Bass Bluetooth speaker.

How to Pair Two Sony XB 12

Covers how to pair two Sony XB 12 Bluetooth speakers together, which lets you create a stereo (L + R) set.  The only extra cost is that you must have two XB 12s to get stereo sound, because individually, these speakers are monophonic.

Picture of the L and R lights on the Sony XB 12 wireless Bluetooth speaker.
The L and R lights on the Sony XB 12.

How to Pair Two Sony XB 12, Step by Step

Prepare the Two Speakers for Pairing

    1. Start with both speakers powered OFF.
    2. Power up the first speaker, and watch for the Power / Pairing lamp to begin flashing white.
    3. Press and hold the Add button for around three seconds, until the XB 12 beeps.
    4. Next, power up the second XB 12.  Again, its Power / Pairing lamp should start flashing blue.  Note that you have one minute to do this after putting the first speaker in Add mode.  Otherwise, that speaker times out, and reverts to a single BT speaker configuration. If this happens, power down both speakers, and start over with step 1.




How to Pair Two Sony XB 12 in Double Mode

    1. Press and hold the Add button on the second speaker for approximately three seconds, until this XB 12 beeps. The Power / Pairing lamps on both speakers should be flashing white now, and the units are now functioning as a single Bluetooth speaker. You’ll also see the L and R lamps on both speakers glowing steadily. See these lights in the next picture. They tell you which speaker will play the left stereo channel, and which will play the right.
    2. Then, pair your Bluetooth source device to your XB 12 speaker set that you just created.
    3. Set the volume to a moderate level using the controls on either speaker.
    4. Begin playing something on your BT source device, and you should hear it play on both XB 12 speakers.
    5. Then, adjust the volume using the controls on one or the other speaker.  Adjusting volume on one also changes it on the other.

Switching Double Mode to Stereo Mode

    1. To switch between Double Mode and Stereo Mode, press and release the Add button on one of the speakers. When in Double Mode, each speaker plays a mono version of the content, which contains both the left and right channels.  So in this mode, both the L and R lamps light up on both speakers.  But in Stereo Mode, one speaker plays the left channel while the other plays the right.  The L light on the left speaker glows in this case while the R lamp is OFF.  The reverse happens on the right speaker in Stereo Mode.  That is, the L lamp is OFF and the R lamp is ON.

How to Break the Stereo Pair Arrangement

To end this speaker tethering, simply turn off both speakers.

Other Sony XB 12 Posts

    1. Sony XB 12 Orange Light Stays On
    2. Sony XB 12 Watts Figures
    3. Sony XB 12 Add Button Explained
    4. Sony XB 12 Charger Types that Work
    5. Connect Sony XB 12 Instructions

Related Posts to How to Pair Two Sony XB 12

    1. How to Pair Sony XB 10
    2. How to Pair Sony SRS XB31
    3. How to Pair Sony Speaker SRS-XB13
    4. How to Pair Sony XE 300

References

    1. Official Sony XB 12 Support Page
    2. Where to Buy the Sony XB 12

Revision History

    • 2023-04-13: First published.