To link the Ultimate Ears Wonderboom 1 with a Bluetooth source device for the first time, or to reset the connection information on that device, you must know how to put it in pairing mode. This makes the Ultimate Ears Wonderboom 1 call out its Bluetooth name and current linkage data on the BT airwaves. So in this post, we show how to put Ultimate Ears Wonderboom 1 in pairing mode, so you can connect it to phones, tablets, computers, and smart speakers.
First, turn on the Ultimate Ears Wonderboom 1 by pressing its Power button once.
See this button in the next picture.
The unit then powers ON. Further, the lamp on the top panel glows steady white, depending on Ultimate Ears Wonderboom 1’s current battery charge state. This light may blink red if your battery is close to dead. But for this exercise, we assume a full battery.
Yet whether the speaker is paired or not, you can start pairing mode as follows.
Now, to be able to find your speaker on your source Bluetooth device, place it into pairing mode. For that, press and hold in the Pairing button, until the speaker makes rising pitch sound.
When you press this button, the speaker makes a rising plunka-dunka-dunk dunk pairing sound. Plus, the top panel Pairing Mode lamp inside the Pairing Mode button starts quickly blinking white.
Next, while the Pairing Mode light is blinking, you should see your Wonderboom on any in-range phone, computer, tablet, or smart speaker, as shown next.
Describes How to Run Battery Check On UE Wonderboom 1, and also, how to know…
Describes How to Run Battery Check On Ultimate Ears Wonderboom 1, and also, how to…
Describes How to Run Battery Check On Wonderboom 1, and also, how to know if…
Describes How to Run Battery Check On Ultimate Ears Wonderboom, and also, how to know…
Describes How to Run Battery Check on UE Wonderboom, and also, how to know if…
Describes How to Run Battery Check On Logitech Wonderboom, and also, how to know if…