To link the Wonderboom 1 with a Bluetooth source device for the first time, or to reset the connection information on that device, you must know how to put it in pairing mode. This makes the Wonderboom 1 call out its Bluetooth name and current linkage data on the BT airwaves. So in this post, we show how to put Wonderboom 1 in pairing mode, so you can connect it to phones, tablets, computers, and smart speakers.
First, turn on the Wonderboom 1 by pressing its Power button once.
See this button in the next picture.
The unit then powers ON. Further, the lamp on the top panel glows steady white, depending on Wonderboom 1’s current battery charge state. This light may blink red if your battery is close to dead. But for this exercise, we assume a full battery.
Yet whether the speaker is paired or not, you can start pairing mode as follows.
Now, to be able to find your speaker on your source Bluetooth device, place it into pairing mode. For that, press and hold in the Pairing button, until the speaker makes rising pitch sound.
When you press this button, the speaker makes a rising plunka-dunka-dunk dunk pairing sound. Plus, the top panel Pairing Mode lamp inside the Pairing Mode button starts quickly blinking white.
Next, while the Pairing Mode light is blinking, you should see your Wonderboom on any in-range phone, computer, tablet, or smart speaker, as shown next.
Temperature differential is the difference between the turn-on and turn-off temperatures on a thermostat, whether…
Here, we give the Cancel Hold on Honeywell Thermostat procedure. But why would hold ever…
You might need to know How to Connect Honeywell WiFi Thermostat to Network for the…
You might need to know How to Connect Honeywell Wireless Thermostat to Router for the…
You might need to know the Connect Honeywell Thermostat to WiFi procedure, to do this…
You might need to know How to Connect Honeywell Thermostat to WiFi for the first…