Screenshot of the iPadOS Bluetooth Settings page, showing the Wonderboom speaker as discovered.

How to Put Wonderboom in Pairing Mode

To link the Wonderboom speaker with a Bluetooth source device for the first time, or to reset the connection information on that device, you must know how to do this on the speaker.  You need this skill because in this mode, this speaker calls out its Bluetooth name and current linkage data on the BT airwaves.  So in this post, we show you how to put the Wonderboom BT speaker in pairing mode, so you can connect it to phones, tablets, computers, and smart speakers.

How to Put the Wonderboom in Pairing Mode

1. Turn On the Speaker

First, turn on the Wonderboom 1 by pressing its  Power  button once.

See this button in the next picture.

Picture of the Wonderboom speaker powered OFF, top view, showing the -Power- button circled.
The Wonderboom speaker powered OFF, top view, showing the -Power- button circled.

The speaker then powers ON. Further, the lamp on the top panel glows steady white, depending on speaker’s current battery charge state. This light may blink red if your battery is close to dead.  But for this exercise, we assume a full battery.

Picture of the glowing -Power- button on the Wonderboom speaker.
The glowing -Power- button on the Wonderboom speaker.

Yet whether the speaker is paired or not, you can start pairing mode as follows.

2. Press the Pairing Mode Button and Release when the Pairing Lamp Starts Quickly Flashing

Now, to be able to find your speaker on your source Bluetooth device, place it into pairing mode. For that, press and hold in the Pairing button, until the speaker makes rising pitch sound.

Picture of the speaker, top view, showing its -Pairing Mode- button circled.
Top view of the speaker, showing its -Pairing Mode- button circled.

When you press this button, the speaker makes a rising plunka-dunka-dunk dunk pairing sound. Plus, the top panel Pairing Mode lamp inside the Pairing Mode button starts quickly blinking white.





3. Done with How to Put Wonderboom in Pairing Mode

Next, while the Pairing Mode light is blinking, you should see your Wonderboom 1 on any in-range phone, computer, tablet, or smart speaker, as shown next.

Screenshot of the iOS Bluetooth Settings page, showing the Wonderboom speaker as discovered in pairing mode.
iOS Bluetooth Settings page, showing the Wonderboom speaker as discovered in pairing mode.

Other Posts About the Wonderboom Wireless Speaker

    1. Wonderboom Battery Level, How to Check
    2. How to Test Wonderboom Battery Life
    3. Wonderboom Speaker Not Charging, How to Fix
    4. How to Connect to Wonderboom Speaker
    5. How to Turn Off Wonderboom Bluetooth Speaker

Related Posts to How to Put Wonderboom in Pairing Mode

    1. How to Put UE Megaboom 3 in Pairing Mode
    2. How to Put JBL Pulse 3 in Pairing Mode
    3. JBL Boombox 2 How to Put Into Discovery Mode
    4. How to Put JBL Clip 4 in Pairing Mode
    5. JBL Flip 6 How to Put in Pairing Mode

References 

    1. Wonderboom BT Speaker Official Product Page at UltimateEars.com

Revision History

    • 2022-09-07: First published.
%d bloggers like this: