This speaker comes equipped with a set of party LED lights that, by default, blink, pulsate and scan in many colors to the beat of whatever you stream to the speaker. However sometimes, you may not want a party atmosphere, like when you want to play the speaker while drifting off to sleep or during the day in a bright area, where you can’t see the lights anyhow. So we show here how to turn off the Sony XB32 lights for just these situations.
To turn off the lights, you need to find the LIGHT-BATT button. We find this control on the back of the speaker, inside the ports compartment, as we see in the next picture.
These lamps, which light the top, bottom, and sides of the unit are programmed to display their light show by default.
They flash any time the speaker is ON, either when fresh out of the box, or after a factory reset.
Then when you want to turn them back on again, simply repeat what you did above. I.e. Press and hold in the LIGHT-BATT button for three seconds. At that point, the party lamps will resume their usual show.
Gives the hard reset JBL Clip 2 speaker procedure, to restore its default settings and…
Gives the reset JBL Clip 2 procedure, to restore its default settings and state. This…
Gives the hard reset JBL Clip 2 procedure, to restore its default settings and state. …
In this post, we explain how to read the charge indicator lamps on the JBL…
Describes how to check battery level on the JBL Go 3. Now the status lamp…
To check battery on the JBL Go 3 speaker, the status lamp tells about the…