We explain three ways for how to turn off the Sony XG 500 portable BT speaker here. Now most speakers have a Power button that Sony prominently places on the unit so it’s easy to locate. Indeed, this speaker is no exception to this pattern, as we find its Power button near the bottom in the button panel. See this next.
There’s also a status lamp, just above the Power button, that glows green as long as the speaker is ON, but goes dark when you turn off the speaker. E.g. We point out this lamp in the next picture.
This lamp glows when the speaker is ON, as seen above.
To power down this unit, press the Power button. Then release after a quarter second or so. Also, you needn’t hold it in for too long for the unit to see your press and then shut itself down.
When the speaker goes off, all lamps on the unit stop glowing, except for possibly the orange CHARGE lamp. See this in the next picture.
This light continues glowing when the speaker is recharging, no matter whether the speaker itself is ON or OFF. Note that the CHARGE lamp does not indicate speaker power status. But it will stop glowing when the battery reaches full charge or you disconnect the charger from the speaker. It should not glow when the speaker is OFF and you have no charger connected.
Moreover, this speaker makes no sound when it shuts OFF, although if it is playing something, this sound will stop right away.
But if pressing the Power button does not turn off the speaker, you can try resetting it.
And if that doesn’t work, you can disconnect the speaker from your charger, and let it run dead. Then it will certainly die off. At that point, and hopefully, when you recharge it, the Power button will once again work as expected. But if not, the speaker may be defective, and so you might just have to replace it.
If you’ve paired the speaker with a source device that has the Sony Music Center app, you can shut down the XG 500 from there as well.
First, find the app on your device, and tap to start it up.
In our test, the app brings up the home page for the XG 500 as follows.
Tapping the “…” button brings up the Settings page.
The app then asks you if you really want to shut off the speaker, as we see next.
Hitting OK shuts down the XG 500. The speaker makes the power-down sound, its lights go out, and the Bluetooth connection with your source device then ends. You can restore this connection however, by simply bringing your source device close to the 300, and then powering up the speaker again.
By default, the XG 500 will shut down after fifteen (15) minutes of inactivity. E.g. No music is playing on the speaker and no button presses in that time that would reset the timeout clock.
Explains the Wonderboom connect 2 speakers routine, so that they both play the same audio…
This post shows how to sync the Wonderboom with common Bluetooth devices. So first, start…
This post shows how to connect Wonderboom with common Bluetooth devices. So first, start with…
The Honeywell thermostat waiting for equipment condition sometimes happens on these smart thermostats. So these…
When your JBL Boombox won't turn ON, this has several possible causes. Either it is…
You can adjust the bass of the JBL Flip 5 speaker by turning ON and…