JBL Bluetooth Speaker Connect Instructions

JBL Charge 4 wireless speaker, top view, showing the -Power- and -Bluetooth- buttons lit and highlighted.

This post gives JBL Bluetooth speaker connect instructions, as done on an iPad Air tablet, but it works in similar fashion on other tablets and smart phones as well. Then, once you connect the speaker to your device, you can stream audio content to it from any source that your source device can stream.

JBL Bluetooth Speaker Connect Instructions, Step by Step

With your speaker powered off (power button is dark), run through this routine to pair it to your iPad, iPhone, or iPod Touch iOS mobile device. We’re using an iPad Air tablet in this demo.

1. Bring Up the Home Screen on your iPhone

Press the Home button to reveal the device’s Home screen.

2. Find the Settings App

We found ours on the second page of our home screen, as shown next.

iPad Home Screen with the -Settings- app highlighted by an arrow.

3. Bring up the Settings App

Tap the Settings app icon.

The source device then displays the first page of its settings, as shown in the next step.

4. Go to Bluetooth Settings to Continue with JBL Bluetooth Speaker Connect Instructions

Our Bluetooth settings screen displays as follows. Note that our Bluetooth is enabled here. But since our speaker is currently turned OFF, it does not show up in the Bluetooth devices list. Also, you wouldn’t see it if you’ve never connected the speaker with your phone / tablet before. See this as shown in this list of previously paired Bluetooth devices, shown next.

An iPad Air, showing previously paired Bluetooth devices list. Note that there’s no JBL Bluetooth speaker now.

5. Switch On your JBL Bluetooth Speaker

Power on the BT speaker by quickly pressing its Power button. See this pointed at by the green arrow in the next picture.

A typical JBL Bluetooth speaker, powered off. Showing the -Power- button highlighted.

The speaker then powers up.

But since your iPhone does not know about this speaker, the speaker will not pair with the phone automatically. The Power light then comes on, and this denotes this not-paired state in our speaker by glowing solid white, as shown next.

The speaker, powered On, not paired. Showing the glowing white power button highlighted.

6. Put your JBL Bluetooth Speaker into Pairing Mode

Now, to see your speaker on your source device, put the speaker into Bluetooth discovery / pairing mode by pressing and releasing the Bluetooth button, as shown in the next picture.

The speaker, powered On, not paired. Showing its Bluetooth discovery mode button highlighted.

When you press the Bluetooth pairing mode button, the speaker makes a repeating single pluck guitar note sound several times. Also, the Power button changes from a solid white glow to flashing blue in our case. See this next.

The speaker in Bluetooth discovery mode. The -Power- button is flashing blue and highlighted.

7. Find your Speaker on your Source Device, to Continue with JBL Bluetooth Speaker Connect Instructions

See the screen shot next. We found ours, as pointed at by the blue arrow, as shown next.

The iPad Air Bluetooth settings screen, showing a JBL Charge 3 speaker discovered but not paired.

8. Next, Connect your Source Device with the JBL Bluetooth Speaker

Tap the listed speaker in the Other Devices section of the Bluetooth devices list, shown above.

Your source device then pairs with the speaker (“JBL Charge 3” in this scenario).

The tablet’s Bluetooth Settings screen then changes to look something like the following.

The iPad Air Bluetooth Settings page, showing the JBL Bluetooth speaker paired with our tablet.

Note that the JBL Bluetooth speaker now shows as connected on your iPhone, as pointed at by the Blue arrows in the last picture.

9. Done with JBL Bluetooth Speaker Connect Instructions !

We have now successfully connected a JBL Bluetooth speaker with an iPhone like tablet. This procedure also works when pairing with other Apple devices, although the screen faces may be somewhat different.