JBL Charge 5 Speaker Blinking White Light While Charging

The battery level meter gauge showing a full charge on the JBL Charge 5 Speaker.

The JBL Charge 5 speaker has a a blinking white light while charging, in its front lower area. This is normal, and it displays battery status as it charges. Whether it’s draining or charging. So it displays charging progress. Or it shows how full the battery is at a given time while charging. It also tells you how much “juice” the battery has left as the battery discharges.

JBL Charge 5 Speaker Blinking White Light While Charging: How to Read It

1. The White Light is Entirely Dark

When you power down the Charge 5 with no charger connected, no lamps light up, as we see next. This bar is also dark when a charger IS working but the battery is already full.

The dark JBL Charge 5 speaker white light.

2. JBL Charge 5 Speaker Blinking White Light While Charging: Shows Battery Recharging Progress

There are five tiny LED lamps inside the 5, that illuminate the charging bar in various degrees. These light in succession as the speaker charging fills the battery. The Charge 5 is charging when you see part of the bar blinking white. When the battery is nearly dead, the bottom edge of the bar blinks white while charging. Then as charging continues, more of the bar lights up, and the flashing end of the bar moves upward.

Note though, that you may see the bottom most part of the light blinks red. This does not mean that charging is proceeding. Instead, it means that the speaker battery is critically low and that you should recharge the 5 immediately.

The flashing red light.

It only flashes red like this when the battery is nearly dead and AC power is not present. But when you do that, this red flashing light changes to blinking white. Remember though, that this light never flashes red while charging.

3. When All Lamps Light Up Solid, Charging is Complete

As charging continues, more of the LEDs on the blinking white light glow solid. That is, the flashing LED moves further up, until reaching the topmost area of the bar.

Battery charging is complete when all but the very last little segment of the bar lights solid. That last part continues to blink for several minutes. Again, you know that charging is occurring if one of the battery charge level lamps is flashing white.

Note that during the charge cycle, part of the light bar is dark (top most portion). This lets you know about how much more the battery must charge before reaching fullness.

The battery recharge cycle finishes when the entire battery status gauge goes dark, as we see above. Thus, the battery is no longer charging when all lamps are OFF. Even with the AC charger still connected, no part of the light glows when the battery is full.

4. This Lamp is Also a Battery Charge Remaining Meter

When unplugged from the charger, what was the battery charging indicator becomes the battery charge left light. The more lights lit, the fuller the battery. The fewer glowing lamps, the less run time left. These lamps show battery status briefly just after you power up the Charge 5. They also show this whenever you tap the volume buttons. To save power, these lamps go dark after some seconds. So to see the charge remaining indication again, just punch the volume UP or DOWN button.

The charging meter showing a full charge on the JBL Charge 5 speaker.

The last picture shows the 5 powered ON, with the entire white light bar aglow. This means that the battery is between eighty and one hundred percent full.