The battery level meter gauge showing a full charge on the JBL Charge 5 Speaker.
The JBL Charge 5 speaker has a charging indicator in its front lower area. This displays battery status. Whether it’s draining or charging. So it displays charging progress. Or it shows how full the battery is at a given time while charging. It also tells you how much “juice” the battery has left as the battery discharges.
When you power down the speaker with no charger connected, no lamps light up, as we see next. This bar is also dark when a charger IS working but the battery is already full. The Charging Indicator is just to the left of where the USB-C charging cable plugs into the speaker.
There are five tiny LED lamps inside the speaker, that illuminate the Charging Indicator bar in various degrees. These light in succession as the charging fills the battery. The speaker is charging when you see part of the bar blinking white. When the battery is nearly dead, the bottom edge of the bar blinks white while charging. Then as charging continues, more of the bar lights up, and the flashing end of the bar moves upward.
Note though, that you may see the bottom most part of the indicator blink red. This does not mean that charging is proceeding. Instead, it means that the battery is critically low and that you should recharge immediately.
It only flashes red like this when the battery is nearly dead and AC power is not present. But when you do that, this red flashing light changes to blinking white. Remember though, that this light never flashes red while charging.
As charging continues, more of the LEDs on the Charging Indicator light up solid. That is, the flashing LED moves further up, until reaching the topmost area of the bar.
Battery charging is complete when all but the very last little segment of the indicator lights solid. That last part continues to blink for several minutes. Again, you know that charging is occurring if one of the battery charge level lamps is flashing white.
Note that during the charge cycle, part of the indicator is dark (top most portion). This lets you know about how much more the battery must charge before reaching fullness.
The battery recharge cycle finishes when the entire battery status gauge goes dark, as we see above. Thus, the battery is no longer charging when all lamps are OFF. Even with the AC charger still connected, no part of the indicator glows when the battery is full.
When unplugged from the charger, what was the battery charging indicator becomes the battery charge left indicator. The more lights lit, the fuller the battery. The fewer glowing lamps, the less run time left. These lamps show battery status briefly just after you power up the speaker. They also show this whenever you tap the volume buttons. To save power, these lamps go dark after some seconds. So to see the charge remaining indication again, just punch the volume UP or DOWN button.
The last picture shows the speaker powered ON, with the entire Charging Indicator aglow. This means that the battery is between eighty and one hundred percent full.
If you run the JBL Portable app, you can see the speaker’s charging indicator there too. Just pair it with this device and start the app.
Then, once the app detects the 5, it displays the its home page as we see next.
The indicator we point out with the dark blue arrow. It shows how full the battery in the speaker is. The more of that bar that is green in color, the fuller the battery.
Gives a safe routine to defrost a freezer fast with a heat gun. now a…
You can charge the JBL Clip 3 conveniently via the hidden USB charge port. Here,…
The Charge 3 JBL comes with an AC charger adapter, whose specs , type, and…
We review the Panasonic model NN-SN778 here. Now it comes packed with high power output. …
The common Honeywell thermostat offers several ways (at least) to cut your heating and cooling…
To check battery on the JBL Go 3 speaker, the status lamp tells about the…