The All Dark JBL Charge 1 battery indicator lamps.
We give the JBL Charge reset directions, to return this BT speaker to default out-of-box settings. Resetting also wipes any prior connected BT devices from its memory. Clearing these stops the Charge from pairing to any nearby Bluetooth devices afterwards.
Also, you might reset to prepare the speaker for sale or re gifting, or simply, to stop it from pairing with devices you no longer wish it to pair with.
Press and hold the Power button until that button lights up and the electronic blip sound plays.
The Power button appears in the next picture, as we point out there with the dark blue arrow.
Once you press and release, the Power button then lights up, as we see next.
The Flip makes a short low-to-high tone blip sound when it powers on. It is then ready for reset after this little chirp finishes.
Now it may or may not pair with a device automatically because this depends on whether there are any in-range Bluetooth devices that know about this speaker. But whether paired or not though, reset works the same way, as follows.
Find the Power and DOWN Volume (-) buttons. The Power button is the circular button just left of center of the buttons panel. The Volume DOWN (-) button is just to the right of the Power button,
The Charge 1 then enters reset.
Then after a short pause, it turns OFF. Specifically, the Power lamp and battery meter lamps go dark, and the speaker makes the power-down high-low tone blip sound.
Next, power on the unit again, as we detail in step 1 above.
Note that after reset, the speaker comes up in Bluetooth discovery mode.
When the Bluetooth button blinks blue and red, the Charge is in pairing mode. So it is not currently paired. Indeed, we expect it would not pair to anything after reset, even in-range devices.
The reset routine is now complete. So you may safely sell or gift the speaker, or pair it again with your favorite Bluetooth devices.
After reset, the speaker no longer automatically connects with any earlier paired Bluetooth device that is in range and in pairing mode. Thus, to restore automatic Bluetooth pairing, you would first manually pair the Charge with a source device. Then, any time that both speaker and that device have Bluetooth turned on, pairing would automatically happen once again.
Shows how to connect HP DeskJet 3630 series to WiFi. Note that doing this will…
Here, we show how to reset the Wonderboom speaker version 2. which returns it to…
We give here the JBL Clip reset directions, that return it to its default settings…
The JBL Boom Box JBL by Harman Kardon is a moderate to higher power, boom…
The JBL Boombox 1 speaker by Harman Kardon is a moderate to higher power, boom…
The JBL Boombox speaker by Harman Kardon is a moderate to higher power, boom box…