Batteries

JBL Wonderboom 1 Battery Life

Covers the details of JBL Wonderboom 1 battery life. Describes how to know if the battery life is shortening over time, and what the amount of life left per recharge is.

JBL Wonderboom 1 Battery Life: Step by Step Monitoring

1. First, Turn ON the JBL Wonderboom 1

You won’t be able to read battery charge status unless the speaker is ON.

The JBL Wonderboom 1 top view. Showing the dark -Power- button.

To turn on the speaker, press and release the Power button, circled in the last picture.

The little lamp in that button should then come on, as shown next, and the speaker should make its startup sound.  If it does not, then the battery could be completely dead.

The glowing -Power- button, which you can read to check JBL Wonderboom 1 battery life.

But as long as there’s some juice in the battery, the speaker should power up.  When it does, move on to the next step.

2. Press and Release the Volume UP and Volume DOWN Buttons to Continue with JBL Wonderboom 1 Battery Life Details

Press and release the center areas of the Volume UP and Volume DOWN buttons at the same time.  Find these areas in the picture shown next.

The Volume UP(+) and Volume DOWN (-) buttons.

When you press these buttons together, the speaker makes one to four “blunk” sounds to tell you how full the battery is.  Four blunks means that the battery has between 75 and 100 percent charge.  Three blunks, and the battery has between 50 and 75 percent charge.  Two blunks denotes that you have between 25 and 50 percent charge in the speaker’s battery.  And finally, one blunk means between 0 and 25 percent charge.

Also, when the Wonderboom battery gets critically low, the Power lamp starts flashing red.

Press these buttons any time the speaker is ON, to check how full the battery is.  The number of blunks you hear, lets you roughly guess how much time you have left to play the speaker, before it goes dead.  Since a fully charged Wonderboom plays for roughly ten hours.  So four blunks means that the speaker has between 7.5 and 10 hours of play time left before it goes dead.  Three blunks means that it will play for another 5 to 7.5 hours.  Two blunks means between 2.5 and 5 hours of music time left.  And 1 blunk means that you’ll get between 0 and 2.5 more hours of play time.

3. Is the Battery Life Shortening Over Time?

When the speaker is new, and using a full power USB charger, the Wonderboom charge time is about 2.8 hours to reach a full charge.

And, the fully charged battery should last for around ten hours of play time before going dead.

A sign of a bad battery, is that it goes dead too fast, or takes too little or too much time to fully charge. So if you fully charge your speaker, but it only plays for under eight hours before dying, its battery may be bad, and unable to hold a full charge anymore.

The JBL Wonderboom 1 front top view. Showing the -Power- button glowing steady red.

If the JBL Wonderboom 1 battery takes longer than three hours to completely recharge, this could also mean a failing battery.  It could mean too that the charger you’re using is not strong enough to recharge the speaker in the specified charge time of 2.8 hours.

Also, slow charging can happen because your charge cord is too thin.  So for best results, we suggest using a full-current USB cable (one that easily carries 2.1 amps). 

Other JBL Wonderboom 1 Posts

    1. How to Sync
    2. How to Check Battery
    3. How to Check Battery Of
    4. Won’t Turn ON or Charge
    5. How to Connect

References

    1. Official JBL Wonderboom 1 Support Page
    2. Where to Buy the JBL Wonderboom 1
admin

Recent Posts

How to Connect Honeywell WiFi Thermostat to Router

You might need to know How to Connect Honeywell WiFi Thermostat to Router for the…

3 mins ago

Connect Honeywell WiFi Thermostat to Router

You might need to Connect Honeywell WiFi Thermostat to Router for the first time, or…

12 mins ago

Connect Honeywell Thermostat to Internet

You might need to ceconnect your Honeywell thermostat (t-stat) to the internet for the first…

28 mins ago

Change Time and Day on Honeywell Thermostat

.You can manually set the time and day on the Honeywell thermostat. But only when…

15 hours ago

How to Fix Honeywell WiFi Thermostat Not Cooling Down

Discusses How to Fix Honeywell WiFi Thermostat Not Cooling Down. Now this problem can happen…

18 hours ago

How to Register Honeywell WiFi Thermostat RTH9580WF

Gives the Register Honeywell WiFi Thermostat RTH9580WF procedure online, on the Honeywell Total Connect Comfort…

18 hours ago