To link the JBL Wonderboom Bluetooth Speaker with a source device for the first time, or to reset the connection information on that device, you must know about the JBL Wonderboom Bluetooth Speaker pairing mode. You need this skill because in this mode, this speaker calls out its Bluetooth name and current linkage data on the BT airwaves. So in this post, we show this mode in action, so you can connect it to phones, tablets, computers, and smart speakers.
First, turn on the unit by pressing its Power button once.
The speaker then powers ON. Further, the lamp on the top panel glows steady white, depending on speaker’s current battery charge state. This light may blink red if your battery is close to dead. But for this exercise, we assume a full battery.
Yet whether the speaker is paired or not, you can start pairing mode as follows.
Now, to be able to find your speaker on your source Bluetooth device, place it into pairing mode. For that, press and release the the Pairing button.
When you press this button, the speaker makes a rising plunka-dunka-dunk dunk pairing sound. Plus, the top panel Pairing Mode lamp inside the Pairing Mode button starts quickly blinking white.
Next, while the Pairing Mode light is blinking, you should see your speaker on any in-range phone, computer, tablet, or smart speaker.
Covers the Remove Permanent Hold on Honeywell Thermostat procedure. Now this indeed begs the question…
How Do You Tell That JBL Flip 3 is Charging? Well, this Bluetooth speaker sports…
Here, we give the Remove Temporary Hold on Honeywell Thermostat procedure. Now this begs the…
The most "meaty" part of installing a new Honeywell WiFi thermostat, is correctly wiring it…
Temperature differential is the difference between the turn-on and turn-off temperatures on a thermostat, whether…
Here, we give the Cancel Hold on Honeywell Thermostat procedure. But why would hold ever…