Bluetooth Speakers

Logitech Wonderboom 1 Check Battery

Covers the Logitech Wonderboom 1 check battery procedure, and also, how to know if the battery is degrading over time.

Logitech Wonderboom 1 Check Battery: Step by Step

1. First, Turn ON the Logitech Wonderboom 1

You won’t be able to read battery charge status unless the speaker is ON.

The Logitech Wonderboom 1 top view. Showing the dark -Power- button.

To turn on the speaker, press and release the Power button, circled in the last picture.

The little lamp in that button should then come on, as shown next, and the speaker should make its startup sound.  If it does not, then the battery could be completely dead.

The Logitech Wonderboom 1 powered ON. Showing the glowing -Power- button. Gives some indication of battery charge present.

But as long as there’s some juice in the battery, the speaker should power up.  When it does, move on to the next step.

2. Press and Release the Volume UP and Volume DOWN Buttons to Hear the Level Sounds

Press and release the center areas of the Volume UP and Volume DOWN buttons at the same time.  Find these areas in the picture shown next.

The -Volume UP(+)- and -Volume DOWN (-)- buttons.

When you press these buttons together, the speaker makes one to four “blunk” sounds to tell you how high the battery is.  Four blunks means that the battery has between 75 and 100 percent charge.  Three blunks, and the battery has between 50 and 75 percent charge.  Two blunks denotes that you have between 25 and 50 percent charge in the speaker’s battery.  And finally, one blunk means between 0 and 25 percent charge.

Also, when the Logitech Wonderboom 1 battery gets critically low, the Power lamp starts flashing red.

Press these buttons any time the speaker is ON, to check the battery.  The number of blunks you hear, lets you roughly guess how much time you have left to play the speaker, before it goes dead.  Since a fully charged Logitech Wonderboom 1 plays for roughly ten hours.  So four blunks means that the speaker has between 7.5 and 10 hours of play time left before it goes dead.  Three blunks means that it will play for another 5 to 7.5 hours.  Two blunks means between 2.5 and 5 hours of music time left.  And 1 blunk means that you’ll get between 0 and 2.5 more hours of play time.

Other Logitech Wonderboom 1 Posts

    1. The Buttons Defined
    2. How to Sync
    3. How to Turn ON
    4. Factory Reset Directions

References

    1. Official Logitech Wonderboom 1 Support Page
    2. Where to Buy the Logitech Wonderboom 1
admin

Recent Posts

How to Connect Honeywell WiFi Thermostat to Network

You might need to know How to Connect Honeywell WiFi Thermostat to Network for the…

1 hour ago

How to Connect Honeywell Wireless Thermostat to Router

You might need to know How to Connect Honeywell Wireless Thermostat to Router for the…

1 hour ago

Connect Honeywell Thermostat to WiFi

You might need to know the Connect Honeywell Thermostat to WiFi procedure, to do this…

2 hours ago

How to Connect Honeywell Thermostat to WiFi

You might need to know How to Connect Honeywell Thermostat to WiFi for the first…

2 hours ago

How to Connect Honeywell Thermostat to Router

You might need to know How to Connect Honeywell Thermostat to Router for the first…

2 hours ago

How to Connect Honeywell WiFi Thermostat to Router

You might need to know How to Connect Honeywell WiFi Thermostat to Router for the…

2 hours ago