Here, we give Logitech Wonderboom 1 hard reset directions. These restore the default settings. Factory resetting works as follows.
Wonderboom hard reset wipes any memorized Bluetooth devices from memory. Clearing this data prevents the unit from pairing to any nearby Bluetooth devices afterwards. Plus, you might do this to re gift the the Logitech Wonderboom 1. Or, you just wish to stop its auto pairing with devices you no longer play through lt.
Press and release the Power button. The status lamp in that button lights and you hear a power-up sound. We’ve circled the Power button in the next picture.
Then, the status light comes on solid or it blinks, as shown next.
The Logitech Wonderboom 1 makes a unique sounding turn-on noise. The UE is then ready for hard reset when this sound finishes. It may or may not pair with a device. That depends on whether you have any in-range Bluetooth devices that know about this Logitech Wonderboom 1 and that it have previously paired with as well. Whether paired or not, hard reset works the same way, as follows.
This unit does not reply to reset requests while connected with a source Bluetooth device. So, unpair the Logitech Wonderboom 1 before hard resetting.
Find the Power and Volume DOWN buttons. The Power button is on the top, near the front. Volume DOWN is the long vertical line on the front, near the bottom. See these both pointed out by the green arrows in the next picture.
The Logitech Wonderboom 1 then enters hard reset. Then, in a few seconds, the unit powers off when the reset wraps up. The falling electronic kar-plunk sound goes off. Then the status light in the Power button goes dark.
Next, power on the unit again, as detailed in step 1 above.
After a hard reset, the speaker comes up in ready-to-pair mode again, with the pairing lamp rapidly flashing white.
Reset is done now. So go ahead and let someone else use the speaker. Or pair it once more with your favorite Bluetooth devices.
After a hard reset, the Logitech Wonderboom 1 no longer auto connects with any prior paired Bluetooth devices. Thus, to set up automatic BT pairing, you pair by hand the Logitech Wonderboom 1 with your desired device(s). Then any time that both the unit and device have Bluetooth turned on, pairing again occurs without you having to do anything.
Don’t forget to delete any now-stale connections to the Logitech Wonderboom 1 from your source Bluetooth devices that you set up prior to resetting. These will no longer work. So you’ll want to “forget” them in your source device’s settings pages.
Covers the Honeywell Thermostat Not Heating problem and ways to address it. Now a thermostat…
Honeywell Thermostat Not Cooling can happen for lots of reasons. For example, poor thermostat placement,…
This piece covers the procedure to Clear Schedule on Honeywell Thermostat. Here, we explain doing…
Many Sony speakers, including the SRS X5, feature a status light that glows orange while…
We've played compact discs (CDs) for over thirty three years now. We listen to them…
We've played compact discs (CDs) for over thirty three years now. We listen to them…