Make JBL Wonderboom 2 Discoverable

To pair the JBL Wonderboom 2 speaker with a BT source device for the first time, or to refresh the connection information stored on that device, you must know how to launch discovery mode on this unit.  Further, in this mode, the  JBL Wonderboom 2 UE speaker sends its Bluetooth name and current linkage info on the BT airwaves.  So in this post, we give the make JBL Wonderboom 2 discoverable.  Thus you can then join it to phones, tablets, computers, and smart speakers.

Make JBL Wonderboom 2 Discoverable: Step by Step

1. Turn On the JBL Wonderboom 2

First, turn on the speaker by pressing and releasing its  Power  button once.

E.g. See this button, that we point at with the yellow arrow in the next picture.

The speaker then comes on, and the Power button lights up white to signal that power is ON, as shown next.

2. Press the Discovery Mode Button and Release when the Speaker Makes the Discovery Mode Sound

Now, to see this speaker on your source Bluetooth device, place the JBL Wonderboom 2 into discovery mode. For that, press and release the the Discovery Mode button.

E.g. This button we circle in the next picture.

When you press this button, this BT speaker plays a distinctive pairing sound. Plus, that same button begins fast-flashing white.

3. Done with Make JBL Wonderboom 2 Discoverable

While the Discovery Mode button is flashing, you should see your speaker on any phone, computer, tablet, or smart speaker, that is within several feet of it, as seen next. Our speaker here has its default name here, called “Wonderboom 2”.

Other JBL Wonderboom 2 Posts

1. 1. Firmware Upgrades Not Supported
   2. Wattage Values
   3. How to Adjust Volume
   4. Sync Directions
   5. How to Check Charge in the Battery

References

1. 1. Official JBL Wonderboom 2 Support Page
   2. Where to Buy the JBL Wonderboom 2