You may decide to sell or give your Google Home smart speaker to another person. or wish to link it to a different Google account, or connect it to a different Wi-Fi network. So to do these things, we show you how to reset the Google Home Speaker to factory settings.
To unlink this device from its current Google account, to assure that it forgets the Wi-Fi connection information stored within, and to restore it to factory default (fresh out of the box) values, perform the following procedure.
Note that if you’re just trying to correct erratic speaker behavior, you might not have to run a complete reset. So, before resetting, try powering off the Google Home for fifteen seconds. Do this by disconnecting its DC power cable either from the wall outlet, or from the speaker. Then, wait for a quarter minute. Finally, power it up again. This often restores normal operation. But if this power cycling does not solve your issues, then try a reset. Reset also if you wish to give the unit to someone else. Read on for details.
Keep in mind that once reset, you’ll no longer have control of the speaker from the Google account where you controlled it before. So to get control of it again, run through the setup procedure again. There, re link the speaker to that account once more, via the Google Home app.
[display_google_ad]
Once booting completes, go on to step 2.
Once the light ring finishes spinning and flashing in its multi-colored way, and goes completely dark after booting, press and hold the Microphone Mute button, found on the back near the top of the Google Home, for five seconds.
Notice that the ring of lights on the top begin glowing orange as you hold in the button. In varying brightness levels and patterns, these show a sort of countdown to reset that is in progress, as pictured next.
After five seconds or so, the Google Home says in its female voice, “You’re about to completely reset Google Home. To cancel, release the button.” Now is the time to release the Mute button, if you no longer wish to erase all settings.
[display_google_ad]
Keep pressing to continue with the reset.
Next, the orange ring goes out. Then it turns white in a spinning pattern as reset begins, pictured next.
After about ten seconds, the top panel goes dark. Then a system reboot begins, with a multi-colored pattern emerging after the hard reset is complete, as shown next.
Then, you hear the startup complete music and then the speaker speaks, “Welcome to Google Home. To get started, download the Google Home app on a phone or tablet.”
[display_google_ad]
Then, the speaker goes into Setup mode. This means that the unit is now ready to accept setup directives from the Google Home App. The Home tells us this by displaying the four white blips in the light ring in a gradually dimming and then brightening pattern, as shown in the next picture.
You may now feel free to give your Google Home to another without fear. They will not have access to the settings or other personal info in your Google account. Or, you can set up the Google again on your existing account, perhaps with a different WiFi network or device name.
Then, shortly later, the light ring turns white with the four dots glowing. The unit then remains in Setup mode until someone goes through the setup procedure. The speaker will not work fully until set up and linked to a Google account via the internet.
Fast acting. Low odor. Economical. Low skin irritation. Hard to rinse. These phrases describe Lysol…
Fast acting. Low odor. Economical. Low skin irritation. Hard to rinse. These phrases describe Lysol…
Fast acting. Low odor. Economical. Low skin irritation. Hard to rinse. These phrases describe Lysol…
Why would you need to know this Find MAC Address on Honeywell Thermostat procedure? It…
Why would you need to know How to Find Honeywell WiFi Thermostat MAC Address? It…
Why would you need to know How to Find Honeywell WiFi Thermostat IP Address? You…