Resetting Honeywell Programmable Thermostat

Gives the resetting Honeywell programmable thermostat procedure. We show this on the RTH9580WF thermostat, and this method does the following.

• • First, it erases out all custom settings.
  • Then, it resets the network the thermostat connects to to none.
  • Finally, it restores the thermostat back to factory default state.

So, follow the steps below, for Resetting most any Honeywell Programmable Thermostat.

We recommend these directions when fixing network connect problems, because Resetting cuts the chance that faulty settings are causing the t-stat to act funny.

But note that after Resetting, the unit forgets any programmed settings. So you must re enter your WiFi network name and password again. Also, your custom schedules, if any, will disappear as well. As mentioned, Resetting returns the thermostat to the built-in heating and cooling routines. So again, you might want to adjust them again for to your specific needs.

Resetting Honeywell Programmable Thermostat: Before You Start

Get your Thermostat Manual

Before restoring to factory default settings, gather your t-stat manual that shipped with it. Or, find that document online at Honeywell’s web site.

Write Down the Current Thermostat Program Schedule

Write down the current daily program schedule currently stored in the t-stat. Do this if you’ve changed it from the default schedule. If you haven’t changed this since the last time you reset the thermostat, then skip this step.

Record Any Other Settings you’ve Changed from Default

Then, run down through the menus in the t-stat, jotting down any settings that you changed prior that let the thermostat work with your furnace. These include filter-change reminders, WiFi network connection info, system type, t-stat name, location, et al.

Resetting Honeywell Programmable Thermostat: Step by Step

1. First, Tap the  Menu Button on the Touchscreen

Find this button in the picture above, at the top right corner of the screen.

Then, scroll down by pressing the down arrow key, until you see the Preferences button, as shown next.

2. Then, Tap the Preferences Button

When the Preferences screen appears, scroll with the down-arrow key.  Look for the  Restore Factory Defaults button.  We circled this in red in the next picture.

3. Then, Tap the Restore Factory Defaults Button

The thermostat then prompts you to confirm that you surely want to restore the thermostat, as shown next.

4. Then Confirm that you Want to Do This

WARNING: Tapping the green Yes button next, erases all user specific settings. So do not proceed until you feel that you can set it up again after. Get help from a climate control specialist if you’re unsure.

If you wish to proceed, then tap the green Yes button.  Otherwise, tap the red No button.

When you press Yes, the display then shows the Restoring Factory Default Settings screen for a bit, as shown next.

Then, after boot-up, the t-stat prepares to get new data from you.  While it does this, it shows the Please Wait screen as follows.

5. Enter New Startup Data at the Prompts

Then, the thermostat prompts you to enter some initial settings. Finally, this allows it to start up with working default values, as shown next.

Afterwards, follow the prompts. They ask for info about your WiFi network and HVAC system.

6. Resetting Honeywell Programmable Thermostat Done !

At last, you have now reset the thermostat.  So you may now enter new network parameters, or get the t-stat ready for gifting or selling.

Other Honeywell Programmable Thermostat Posts

1. 1. Resetting Honeywell WiFi Thermostat

References for Resetting Honeywell Programmable Thermostat

1. 1. Official Honeywell Programmable Thermostat Support Page
   2. Where to Buy the Honeywell Programmable Thermostat