Sony XB13 Factory Reset Instructions

Sony SRS XB13 front panel buttons.

Gives factory reset instructions for the Sony XB13 to set it back to its default settings. Factory resetting restores the XB13 to factory default state. Plus, it erases any earlier connected Bluetooth devices from its memory. Clearing these stops this unit from pairing to any nearby BT devices. Also, you might factory reset to get this speaker ready for sale or re-gifting, or to stop it from pairing with devices you no longer wish it to connect with.

Sony XB13 Factory Reset, Step by Step Instructions

1. Power UP the Speaker

Press the Power button for a half-second or so and then release it.

E.g. Find the Power button as we show in the next picture.

The -Power- Button on the Sony XB13.

Then, the status light comes on, as shown next.

The -Power- lamp glowing.

The speaker may make a ding-dong tone sound when it powers up, should it pair to a nearby device. Or it may make no sound at all if it does not. Yet whether paired or not, this factory reset to default state routine works the same, as follows.

2. Press and Hold the Play / Pause and Volume UP Buttons At the Same Time

Find these buttons as we show next. Find both of them near the bottom of the speaker, as called out in the next picture.

The Sony XB13 -Play-Pause- and -Volume UP- buttons.

The XB13 then enters factory reset mode.

After a little pause, the speaker powers OFF, and the status lamp goes dark, as shown next. Note that on the SRS XB13, there is no power-down sound.

The -Power- lamp shown as OFF.

3. Check that your Sony XB13 Did Indeed Factory Reset

Next, power on the unit again, as we detail in step 1.

Note that after a factory reset, the XB13 comes up in pairing / discovery mode. The Power lamp blinks blue rapidly to signify this. This is a prompt that you may then look for this speaker on a nearby BT device, and pair to it if you so desire.

4. Done with Sony XB13 Factory Reset !

Factory reset is now done. So you may now gift or sell it, or link it again with your favorite Bluetooth devices.

After a factory reset, the XB13 no longer auto connects with any prior paired Bluetooth device. Thus, to restore automatic pairing, you manually pair it with a device. Then after that, any time that both speaker and that device have Bluetooth turned on, and they’re near to each other, pairing would automatically take place once more.