Here we give the Sony XB40 wireless speaker reset directions, to restore the unit to its default settings. Resetting restores the 40 to factory default state. Plus, it clears any earlier paired Bluetooth devices from its recently-connected-devices list. This stops the speaker from pairing to any nearby Bluetooth devices. Furthermore, you might factory reset the unit to get it ready for sale or re-gifting, or to stop it from pairing wirelessly with devices you no longer wish it to connect with.
Press and release the Power-Pairing button for a half-second or so. Find that button as we see in the next picture. It’s on the top, closest to the right edge of the speaker.
Then, the Power-Pairing button starts glowing, as we see next.
The speaker may make a two-tone sound as it starts, to announce that it has paired, if in fact it sync to a nearby device. Or it may play no sound at all if it does not. But whether the unit connects or not though, this reset routine works the same way, as follows.
Find these buttons as shown next. They are both on the top button panel.
Since one of these buttons is for power, you need to first press the Volume Down button by itself, Then, after a half-second, while holding that one in, press and hold the Power button as well. Doing it this way prevents accidently powering down the speaker before it has a chance to reset.
The XB40 then enters its master reset program.
Then after about a few seconds, the speaker powers OFF, and the Power-Pairing button goes dark. So release the buttons now. Note that on the SRS XB40, there is no power-down sound.
Next, power on the unit again, as detailed in step 1 above.
Note that after reset, the XB40 comes up in discovery mode. The Pairing Status lamp quickly blinks white to let you know this.
This is a signal that you may then look for this speaker on a nearby BT device, and pair to it if you so desire.
This routine is now complete. So you may now sell or gift the speaker, or pair it again with your favorite Bluetooth devices.
After reset, the XB40 no longer automatically links with any Bluetooth device. So to restore auto joining, you manually pair it with a device. Then after that, any time that both speaker and that device have Bluetooth turned on, and are in range, pairing would automatically take place once more.
Covers the JBL Go 3 Firmware Update Instructions. However, we know of no way to…
We show you here How to Factory Reset JBL Go 3 BT Speaker, to restore…
This post gives the procedure to Connect JBL Go 3 to Alexa. Since this pairing…
When the JBL Go 3 Speaker Won't Turn ON, this likely means one or more…
Explains How to Put JBL Go 3 Speaker in Pairing Mode. So first, turn on…
When the JBL Go 3 Won't Turn ON, this likely means one or more things…