Here’s our UE Wonderboom 2 charging procedure. Charging is easy through the sealed micro USB DC in port on the rear bottom of the speaker. First, pick a high current USB AC adapter. Why? Because you do not get this with the UE Wonderboom 2. But the company does offer one that works well for less than twenty US dollars.
Next, connect a micro USB charge cord between the UE Wonderboom 2 and that adapter. Then, plug that power supply into a working AC mains outlet.
Finally after roughly three hours, the speaker fully recharges. Then, you can play it again for around thirteen hours before it runs dead again.
In this demo, we’re using the iClever 24 watt AC USB charger, as shown next. The UE Wonderboom 2 needs 5 volts at about 1.0 amp to charge fully in the shortest time. So this iClever USB wall adapter is indeed strong enough for the job.
Use a dime or penny to open the waterproof seal port cover. This uncovers the micro USB charging port inside, as shown next.
Note that the speaker still charges when running. But depending on your charger, it may recharge a little faster when turned OFF.
Then, plug the small end of your micro USB charge cable into the matching micro USB port, as shown next.
Next, connect the A end of the USB charge cable to the power adapter. In this demo, as we said earlier, we use an iClever 24 Watt 2.1 amp per port USB power adapter along with a generic micro USB cable.
Now that we connected the speaker and charger, we plug the charger into a working AC outlet.
The status light in the power button lights a fading and brightening white pattern on this BT speaker with enough USB power. While no battery status gauge shows charge percentage, the pulsating white lamp means that charging is happening.
Then when the speaker is OFF, this lamp goes out when charging finishes If the speaker is ON, this lamp starts glowing a solid white once more.
Battery charging is finished when the gradually brightening and fading power lamp stops pulsating. Detail: when the speaker is OFF, this lamp goes out when charging finishes But if the speaker is ON, the light starts glowing a solid white once more.
Note that unless you snap this door tightly into place, water might get inside, and too much moisture could damage speaker electronics in there. So, be sure to press the door closed with enough pressure to fully seat it, to help ensure full water resistance. See the correctly closed port door in the next picture.
We have now fully charged our UE Wonderboom 2.
Repeat this routine every ten hours of music play, to keep its battery in top shape for months to come.
Here, we show how to factory reset a Wonderboom to put it back to its…
Gives the connect Logitech Wonderboom to iPhone procedure. Now this can also work with other…
This post gives the Alexa Dot Bluetooth Pairing procedure. These directions include the all Bluetooth…
You can reset all of the smart speakers in the Google Home family. These include…
Here, we walk you through How to Install HP DeskJet 3630 Series Wireless Printer. In…
Perform this HP DeskJet 3632 setup routine to clear out the existing WiFi setting. You…