Wonderboom 1 Not Pairing

This post explains how to avoid the Wonderboom 1 Not Pairing problem, by giving the correct way to pair it. This shows pairing to a typical smart device so that you may play music on that device and have it come through the Wonderboom 1. Start with your Wonderboom 1 shut OFF (all dark LEDs). Then, follow along for pairing it with phones, tablets, laptops, media players, et al.

Wonderboom 1 Not Pairing: The Right Way to Do It

1. Visit the Home Screen of your Smart Device

Press the Home button to get to the  Home   page.  See our screen as shown next.

3. Find the  Settings  App

We found ours on the second page of the  Home  screen.

3. Bring up the Settings App

Tap the Settings app icon.  Find this pointed at in the last picture.

The iPhone then displays the first page of its  Settings  screen, as shown in the next screenshot

4. Go to the Bluetooth Settings Page to Continue with Wonderboom 1 Not Pairing Solution

Tap the  Bluetooth  item, as pointed at by the green arrow in the last screenshot.

The Bluetooth Settings screen then appears as follows. Note that our Bluetooth should be switched ON here.

But since the 3 is currently OFF, it does not show in either the  My Devices  or  Other Devices lists on the tablet yet,  Why?  Because we have yet to connect it with this device for the first time.  Plus, the 3 is not yet transmitting its Bluetooth connection info. See this scenario, that appears as shown next.

Note in this picture that no Wonderboom 1 appears yet.

5. Power Up your Wonderboom 1

Turn on the unit by quickly pressing its  Power  button. See this button, pointed out in the next picture.

The 3 then comes on, and announces this with a rising electronic sound.  The Power button also lights up, as we see next.

If the 3 does not come on, then see our  Wonderboom 1 Power Button Not Working Fixes piece to solve this.

6. Put your Wonderboom 1 into Discovery Mode

Now, to see the 3 on your iPhone, place it into BT discovery mode. For that, press and hold the Bluetooth button located as we see in the next picture. It’s on the top, at the twelve o’clock position in he buttons panel. Release the button when you hear the rising plunks sound.

Also, a lamp in this button starts quickly flashing white.

7. Find your Wonderboom 1 on your Smart Device

See the picture next. We found ours, as pointed out next.

8. Pair with your Wonderboom 1

Tap the listed speaker in the  Other Devices  section of the  Bluetooth Devices  list, shown above. If the unit does not appear on the source device, try moving it closer, powering it off and then back on again. Or at worst, you may have to reset the Wonderboom 1.

Your device then connects with the 3 (appears as “WONDERBOOM 3” in this demo).

The  Bluetooth Settings  screen then changes to display something like the following.

Note that the Wonderboom 1 now appears as connected, as pointed out in the last picture.

9. Done with the Wonderboom 1 Not Pairing Answer

Lastly, we have now successfully paired the 3 with the test  source device.  So now, audio output from that device now plays on the 3.

Other Wonderboom 1 Posts

1. 1. How Do I Know When My Wonderboom 1 Is Fully Charged
   2. Sync Directions
   3. How Long Does a Wonderboom Take to Charge
   4. How to Check Battery
   5. Flashing White Light Troubleshooting

References for Wonderboom 1 Not Pairing

1. 1. Official Wonderboom 1 Support Page
   2. Where to Buy the Wonderboom 1