Wonderboom 2 How to Put In Pairing Mode

To pair your Wonderboom 2 with a Bluetooth source device for the first time, or to update stale connection information in that device, you have to know how to start pairing mode on the speaker. Why? Because in this mode, the speaker transmits  its name and currently valid connection data over the Bluetooth airwaves, which enables other nearby Bluetooth devices to pair to it.  So in this post, we give the Wonderboom 2 How to Put In Pairing Mode routine, to allow you to link it with phones, tablets, computers, and smart speakers.

Wonderboom 2 How to Put In Pairing Mode: Step by Step

1. Turn On the Wonderboom 2

Firstly, turn on the speaker by rapidly pressing its  Power  button.

E.g. See this button that we point at with the yellow arrow, in the next picture.

The speaker then comes on, as pictured next.

2. Press the Pairing / Discovery Mode Button for Two to Three Seconds

Secondly, to be able to discover your speaker on your source Bluetooth device, place it in pairing mode. For that, press and hold the the Pairing button, as circled in the next picture.

When you press this Pairing button, the speaker makes a cool pairing sound. Plus, a lamp in this button starts rapidly flashing white. See this in the last picture, circled in yellow.

3. Done with Wonderboom 2 How to Put In Pairing Mode

Finally, while the Pairing button is blinking, the Wonderboom 2 is now in pairing mode.  So you should  see your Wonderboom 2 on any in-range phone, computer, tablet, or smart speaker, that is within several feet of it, as shown next.

Other Wonderboom 2 Posts

1. 1. Not Connecting Fixes
   2. The Controls Explained
   3. Pair Directions
   4. Won’t Turn ON Troubleshooting
   5. How to Adjust Volume

References

1. 1. Official Wonderboom 2 Support Page
   2. Where to Buy the Wonderboom 2