Wonderboom 3 Pairing Mode

To pair your Wonderboom 3 with a Bluetooth source device for the first time, or to update stale connection information in that device, you have to know about Wonderboom 3 Pairing Mode. Why? Because in this mode, the speaker transmits  its name and currently valid connection data over the Bluetooth airwaves, which enables other nearby Bluetooth devices to pair to it.  So in this post, we show you how to start this pairing mode, to link it with phones, tablets, computers, and smart speakers.

Wonderboom 3 Pairing Mode: Step by Step

1. Turn On the Wonderboom 3

Firstly, turn on the speaker by rapidly pressing its  Power  button.

E.g. See this button that we point at with the yellow arrow, in the next picture.

The speaker then comes on.

2. Press the Pairing / Discovery Mode Button for Two to Three Seconds

Secondly, to be able to discover your speaker on your source Bluetooth device, place it in pairing mode. For that, press and hold the the Pairing button.

When you press this Pairing button, the speaker makes a cool pairing sound. Plus, a lamp in this button starts rapidly flashing white.

3. Done with Wonderboom 3 Pairing Mode Description

Finally, while the Pairing button is blinking, the 3 is now in pairing mode.  So you should  see your Wonderboom 3 on any in-range phone, computer, tablet, or smart speaker, that is within several feet of it, as shown next.

Other Wonderboom 3 Posts

1. 1. Adjusting the Volume
   2. Connect Directions
   3. Sync Procedure

References for Wonderboom 3 Pairing Mode

1. 1. Official Wonderboom 3 Support Page
   2. Where to Buy the Wonderboom 3