Google Home Mini smart speaker with factory default reset In progress, showing scanning white lights on top.
You may decide to sell or give your Google Home Mini smart speaker to another person. Or, you want to link it to a different Google account or a new WiFi network. Well, to unlink this smart speaker from its current Google account and WiFi, a Google Home Mini reset does the trick. Finally, a reset restores the Mini to factory default (fresh out of the box) values. Follow these instructions to reset the Mini when you need to do this.
Note that if you’re just trying to correct erratic behavior of the Google Mini speaker, you may not need to reset. So, before resetting, try powering off the unit for fifteen seconds. Then wait fifteen seconds. Next, power it up again. This often restores proper working. But if simple OFF ON switching does not fix the problem, or you really must reset, then read on.
Keep in mind that once reset, you’ll no longer be able to control the Mini from the Google account where you controlled it from before, unless you run through the setup procedure again, and relink the speaker to that account once more, via the Google Home app.
After boot completes, go on to step 2.
This button is located in the orange area on the bottom of the Mini, near the power cord USB plug.
Once one light in the row of lamps on the top glows yellow, as shown next, the assistant will warn you that you’re about to reset the device and that if you wish to abort the reset, release the reset button now. Continue holding the button in to perform the reset to factory default state.
The first yellow light then comes on, with one more turning on every few seconds until the entire row of four is lit. The reset operation begins shortly thereafter, as long as you keep the reset button firmly depressed.
Do not power off the unit during the reset, as doing so could render it unusable (bricked).
Let go of the Reset button when the Google Mini plays a short chime chord sound and the yellow lights on top go dark.
Reset starts once the lights go out and the Home Mini speaker stays dark for several seconds, as shown next.
After a short pause, the white lights come back on in a scanning marquee pattern for several seconds, as shown next.
After some seconds, the speaker again goes dark as the factory default reset completes.
Then, the reboot after that reset starts, as shown next.
After several to ten seconds, the lights come back on, colored dim gray, and displaying a scanning pattern, as shown next, indicating that a reboot after the reset is in progress.
Several seconds into the reboot, the lights turn multi-colored as shown next.
Then, you hear the startup complete music and then the speaker speaks, “Welcome to Google Home. To get started, download the Google Home app on a phone or tablet.”
This means that the speaker can now accept initialization directives from the Google Home App. The speaker shows four white blips across its top to tell us this, in a dimming then brightening pattern. See this in the next pic.
You may now feel free to give your Google Home Mini smart speaker to another without fear that they’ll have access to the settings or other personal information on your Google account. Or, you can set it up again on your existing account, perhaps with a different Wi-Fi network or device name.
Once the light row turns white with the four dots glowing, the unit remains in setup mode until someone executes the published setup procedure. The speaker will not function until properly set up and linked to a Google account.
Most Bluetooth speakers, including the Wonderboom 2, offer truly portable operation via their lithium ion…
Shows the Wonderboom 3 check battery procedure, and also, how to tell if the battery…
Describes the Wonderboom 2 how to pair routine, to get it playing from your phone,…
Gives the check Wonderboom battery routine, and also, how to know if the battery life…
Gives the Wonderboom 2 reset instructions, which return it to its factory default settings. Resetting…
Explains how to turn OFF Wonderboom 3 here. Now most speakers have a Power button…
