JBL Xtreme Bluetooth speaker, front view, held in hand.
Explains how to charge the JBL Xtreme 1 through its DC input port and the included 19 volt adapter.
In short, first, we suggest that you charge the Xtreme 1 with the included JBL charger. Why? Because this charger meets the speaker’s current needs, and is provided by JBL besides. Presumably, JBL thinks that this is a well-matched charger. After all, they do package it with the Xtreme 1. So, we won’t buck any systems here, and will indeed use that charger. But in a bind, you could fully charge the Xtreme 1 with other vendors’ wall chargers. But we won’t discuss those options in this post.
It’s time to charge this speaker when the battery status gauge shows a single flashing red light.
When you see the blinking red lamp, plug the black barrel DC output charge cord jack into the Xtreme 1. Then, plug the charger into a working wall outlet.
Finally after a few hours, the Xtreme 1 fully charges. Then, play it again for roughly fifteen hours before you have to charge it again.
Firstly as mentioned above, we use the JBL wall charger that comes with the Xtreme 1.
Grasp the orange zipper on the lower back of the Xtreem, and pull it to the left, opening port cover. This exposes the USB power out and charge port inside.
Then, plug the barrel connector end of the wall adapter’s cord into the matching DC input port on the speaker.
Next, plug the charger into an AC outlet.
At least one of the battery status lamps lights on the Xtreme 1 when everything is working correctly. Five lamps on this speaker light in succession as battery charge progresses.
Then battery charging is almost complete when only the last of the charge status lights is either OFF or blinking. The last then blinks for several minutes more to finish off the charge.
The battery recharge cycle finishes when all battery status gauge lights go out.
So the next picture shows the round charging port on the speaker after we took out the charge cord.
Then unless you fully zip up this power port opening flap, water might enter the connector area. It could then damage speaker components inside. So, take great care to fully close this port door for full water resistance.
At last we have now fully charged this Bluetooth speaker. Note that the battery charge status gauge just after turning on the unit after a full recharge. All lamps are aglow.
Finally, repeat this process every fifteen hours of play to keep the battery in good condition. We charge ours when the gauge lights show just one lamp glowing.
Shows how to pair Amazon Echo to Bluetooth speakers. These include the generation 1 and…
Many speakers including this one, feature a status light that glows red while charging /…
Many speakers, including this one, feature a status light that glows red while charging /…
Here we cover the Amazon Echo Dot 3rd generation power cable specs. This is the…
The Sony SRS XB32 speaker charging indicator is a small LED light in the back…
Here we cover the Echo Dot 3rd generation power adapter specs. This is the wall…