The front, right, and top sides of the Sony SRS X5.
Show you how to hard reset your Sony X 5 personal portable speaker to its default settings. Hard resetting restores the X 5 to factory default state. Plus, doing this erases any earlier paired Bluetooth devices from memory. We might want to clear these to prevent this speaker from pairing to any nearby Bluetooth devices. Also, you would best reset your speaker to get it ready for sale or re-gifting, or to stop it from pairing with devices you no longer wish it to connect with.
Press and release the Power button for a half-second or so. Find the Power button as shown in the next picture.
Find the Power button, as shown in the last picture above.
Then, the status light comes on, as shown next. This light we find on the bottom edge of the front of the unit.
Now whether it pairs or not, this hard reset routine works the same way, as follows.
Both of these buttons we find on the top of the speaker, right of center, as called out in the next picture. Both buttons are in the back row. The Volume Down button is in the leftmost position in this row, while the Power button is in the rightmost position.
Since one of these buttons is for power, you need to first press the Volume Down button by itself, Then, after a half-second, while holding that one in, press and hold the Power button. Doing it this way prevents accidently powering down the speaker before it has a chance to reset.
Then, hold both buttons in until all lamps go out, and the speaker shuts down. This takes around five seconds as the speaker hard resets.
Next, the speaker powers OFF, and the Power and Pairing lamps go dark, as shown next. Note that on this speaker, there is no power-down sound when hard reset finishes.
You may release the buttons when all the lights go dark.
Next, power on the X 5 once more, as described in step 1 above.
Note that after a hard reset, this speaker comes up in pairing mode. The Pairing lamp blinks in fast white blips to tell you this. This is a signal for you to look for this speaker on a nearby BT device, and pair to it if you so desire.
The hard reset is now finished. So you may now sell or gift the unit, or pair it again with your favorite Bluetooth devices.
After a hard reset, the speaker no longer automatically connects with any previously paired Bluetooth device. Thus, to restore this auto syncing, you manually pair the X 5 with a device. Then after that, any time that both speaker and that device have Bluetooth turned on, and they’re near to each other, pairing would automatically take place once more.
The JBL Go 2 speaker by Harman Kardon is a low power, hand-held style unit…
Shows how to fix Honeywell wireless thermostat connection failure issues. You might see these on…
Shows how to connect HP DeskJet 3630 series to WiFi. Note that doing this will…
Here, we show how to reset the Wonderboom speaker version 2. which returns it to…
We give here the JBL Clip reset directions, that return it to its default settings…
The JBL Boom Box JBL by Harman Kardon is a moderate to higher power, boom…