To link the Wonderboom 2 UE with a Bluetooth source device for the first time, or to reset the connection information on that device, you must know how to do this on the speaker. You need this skill because in this mode, this speaker calls out its Bluetooth name and current linkage data on the BT airwaves. So in this post, we show you how to put UE Wonderboom 2 into pairing mode, so you can connect it to phones, tablets, computers, and smart speakers.
First, turn on the speaker by pressing its Power button once.
See this button, pointed out by the yellow arrow in the next picture.
The speaker then powers. Further, the pilot lamp on the top panel glows steady white, depending on speaker’s current battery charge state. This light may glow red if your battery is close to dead. But for this exercise, we assume a full battery.
But whether the speaker is paired or not, you can start pairing mode as follows.
Now, to be able to find your speaker on your source Bluetooth device, place it into pairing mode. For that, press and release the the Pairing button, as circled in the next picture.
When you press this button, the speaker makes a rising plunka-dunka-dunk dunk pairing sound. Plus, the top panel Pairing Mode lamp inside the Pairing Mode button starts quickly blinking white.
Next, while the Pairing Mode light is blinking, you should see your UE Wonderboom 2 on any in-range phone, computer, tablet, or smart speaker, as shown next.
.You can manually set the time and day on the Honeywell thermostat. But only when…
Discusses How to Fix Honeywell WiFi Thermostat Not Cooling Down. Now this problem can happen…
Gives the Register Honeywell WiFi Thermostat RTH9580WF procedure online, on the Honeywell Total Connect Comfort…
Here, we show How to Find Honeywell Thermostats Firmware Version that they are currently running.…
Gives our Honeywell RTH8580WF WiFi Thermostats Review. Now these thermostats are a state-of-the-art digital climate…
Covers How to Fix Honeywell Thermostats Not Heating. Now a thermostat not activating the heat…