Here, we give JBL Clip 4 Bluetooth speaker factory reset directions, to return it to its default settings. Factory resetting reverts this speaker to its factory default state. Furthermore, it wipes away any prior paired Bluetooth devices from its memory. Erasing these stops the Clip 4 from pairing to any nearby Bluetooth devices after factory reset. Also, you would do this to get the unit ready for sale or re gifting. Or simply do factory reset to stop it from connecting with devices you no longer wish to use it with.
Press and hold the Power button until the status lamp lights.
First, find the Power button, as we see in the last picture above.
Then, the status light comes on, as the next picture shows.
The speaker makes a rising electric guitar strum sound when it powers up. Then, the speaker can factory reset.
Now the speaker may or may not pair with a device. That depends on whether there are any in-range Bluetooth devices that know about this Clip. Nonetheless, whether paired or not, the factory reset works the same way, as follows.
Find the Volume Up and Bluetooth buttons.
The Volume Up button is on the front of the speaker, near the top, to the right. See it next.
And the Bluetooth button is on the left side of the speaker, as we point out in the next picture.
After you press and hold these two buttons, the speaker then enters its factory reset routine.
Next, after a short pause, the Clip 4 turns off. The status lamp goes dark, and the speaker makes the power-down guitar sound.
Next, power on the Clip 4 again, as we did in step 1 above.
Note that after a factory reset, our speaker comes up in pairing / discovery mode. The status lamp fast flashes white to tell us this. Thus you should now be able to see the speaker in a BT source device when connecting.
Reset is now complete. So you may now sell or gift it, or pair the speaker once more with your favorite Bluetooth devices.
Finally after factory reset, the speaker no longer automatically pairs with any device. Thus, to restore this, you have to first manually pair it with a device. Then later, when the two have Bluetooth ON and are in range, auto pairing would happen again.
The Honeywell thermostat waiting for equipment condition sometimes happens on these smart thermostats. So these…
When your JBL Boombox won't turn ON, this has several possible causes. Either it is…
You can adjust the bass of the JBL Flip 5 speaker by turning ON and…
Gives the hard reset JBL Clip 2 speaker procedure, to restore its default settings and…
Gives the reset JBL Clip 2 procedure, to restore its default settings and state. This…
Gives the hard reset JBL Clip 2 procedure, to restore its default settings and state. …