JBL Flip 6 Pairing

This post gives a JBL Flip 6 pairing routine. This works when pairing with the iPhone, iPod Touch, and the iPad line of Apple phones, media players, and tablets. However, a similar procedure applies to Android devices too.

JBL Flip 6 Pairing: Step by Step

With your JBL Flip 6 OFF, run through this routine to pair it to your mobile device.

We use an iPad Air tablet for this demo.

1. Get to the Home Screen on your Source Device

Firstly, press the Home button to reveal the mobile device’s Home screen.

2. Find the Settings App

We found ours on the second page of the iPadOS home screen on our iPad Air tablet.

3. Bring up the Settings App

Thirdly, tap the Settings app icon.

The device then shows the first page of its Settings page.

4. Go to Bluetooth Settings  to Continue with JBL Flip 6 Pairing

Our BT settings screen displays as follows. Note that Bluetooth is ON here. But since our Flip 6 is currently OFF So, it cannot be in discovery mode. Thus it does not show up in the   Bluetooth Devices   list. Also, we don’t see it since we’ve never paired it with this tablet before.

 

5. Turn On your JBL Flip 6

Then power up the speaker by fast pressing its  Power  button.

The speaker then turns on, and its power lamp lights and the Pairing lamp flashes or glows white.  If blinking, this means that the speaker is ready to receive a connection request.

But since our tablet does not know about this speaker, the Flip 6 will not pair with it automatically.

6. Put your JBL Flip 6 into Discovery Mode

So to see your Flip 6 on your iOS or iPadOS device, start up discovery mode on it. To do that, press and release the Bluetooth button.

When you press this control, the Flip 6 plays a repeating single pluck guitar note. Also, the status lamp changes to a fast flashing white.

7. Find your Speaker on your Mobile Device to Continue with JBL Flip 6 Pairing

See the screen shot next.

8. Pair with your JBL Flip 6

So tap the speaker entry in the Other Devices section of the devices list.

Your source device then pairs with it.

The tablet’s   Bluetooth Settings  screen then changes to look something like the following.  Note the now-connected JBL Flip 6 entry.

9. Done with JBL Flip 6 Pairing !

Finally, we have now paired our Flip 6 with a tablet.

Other Posts About the JBL Flip 6

1. 1. How to Factory Reset a JBL Flip 6
   2. How to Fix the JBL Flip 6 Not Charging Problem
   3. JBL Flip 6 Charger Type and Replacement
   4. JBL Flip 6 Red Light Stays On, How to Fix

References for JBL Flip 6 Pairing

1. 1. JBL Flip 6 Official Product Page
   2. Where to Buy the JBL Flip 6