Screenshot of an iOS Bluetooth Settings page. Showing the Wonderboom 1 as Discovered but not paired.

JBL Wonderboom 1 How to Put In Pairing Mode

To link the JBL Wonderboom 1 with a Bluetooth source device for the first time, or to reset the connection information on that device, you must know how to put it in this mode.  This makes the JBL Wonderboom 1 call out its Bluetooth name and current linkage data on the BT airwaves.  So in this post, we give the JBL Wonderboom 1 how to put in pairing mode procedure, so you can connect it to phones, tablets, computers, and smart speakers.

JBL Wonderboom 1 How to Put In Pairing Mode: Step by Step

1. Turn On the JBL Wonderboom 1

First, turn on the JBL Wonderboom 1 by pressing its  Power  button once.

See this button in the next picture.

Picture of the JBL Wonderboom 1 top view. Showing the dark -Power- button.
The JBL Wonderboom 1 top view. Showing the dark -Power- button.

The unit then powers ON. Further, the lamp on the top panel glows steady white, depending on JBL Wonderboom 1’s current battery charge state. This light may blink red if your battery is close to dead.  But for this exercise, we assume a full battery.

Picture of the glowing -Power- button.
The glowing -Power- button.

Yet whether the speaker is paired or not, you can start pairing mode as follows.

2. Press the Pairing Mode Button and Release when the Pairing Lamp Starts Quickly Flashing

Now, to be able to find your speaker on your source Bluetooth device, place it into pairing mode. For that, press and hold in the Pairing button, until the speaker makes rising pitch sound.

Picture of the -Pairing Mode- button.
The -Pairing Mode- button.

When you press this button, the speaker makes a rising plunka-dunka-dunk dunk pairing sound. Plus, the top panel Pairing Mode lamp inside the Pairing Mode button starts quickly blinking white.

3. Done with JBL Wonderboom 1 How to Put In Pairing Mode

Next, while the Pairing Mode light is blinking, you should see this speaker on any in-range phone, computer, tablet, or smart speaker, as shown next.

Screenshot of the iOS Bluetooth Settings page, showing the JBL Wonderboom 1 as discovered in pairing mode.
iOS Bluetooth Settings page. Showing the JBL Wonderboom 1 as discovered in pairing mode.

Other JBL Wonderboom 1 Posts

    1. Not Turning ON Fixes
    2. Check Battery Procedure
    3. The Wattage Numbers
    4. Power Button Not Working Fixes
    5. Adjust Volume Directions

References

    1. Official JBL Wonderboom 1 Support Page
    2. Where to Buy the JBL Wonderboom 1