Sony Cube Speaker Factory Reset Instructions

Sony SRS X11 cube speaker front view.

Explains the Sony Cube Speaker factory reset instructions, to return this cube speaker to its default fresh-out-of-the-box settings. Factory resetting restores the cube to default factory state. Plus, it erases any earlier paired Bluetooth devices from its memory. Clearing these stops this speaker from pairing to said devices whenever they come into range. Additionally, you might factory reset this speaker to get it ready for sale or re-gifting, or to stop it from pairing with devices you no longer wish it to connect with.

Sony Cube Speaker Factory Reset Instructions, Step by Step

1. Turn the Speaker ON

Press and release the Power button for a half-second or so. Find the Power button as shown in the next picture.

The Sony Cube Speaker -Power- button.

Then, the status light comes on, as shown next. This light we find on the bottom edge of the front of the unit.

The -Status- lamp glowing.

The speaker makes two ding-dong sounding beeps when it powers up, whether it links to a nearby device or not. But whether or not it auto pairs, this reset routine works the same way, as follows.

2. Press and Hold the Volume DOWN , Volume UP, and Power Buttons at the Same Time

Find these buttons as shown next. All three of them we find on the top of the speaker, near the front edge, as called out in the next picture.

The -Power-, -Volume DOWN-, and -Volume UP- buttons.

The cube then enters factory reset mode after a brief pause.

Next, the speaker powers OFF, and the status lamp goes out, as shown next. Note that on this speaker, there is no power-down sound.

The dark -Status- lamp.

3. Check that your Sony Cube Speaker Did Indeed Factory Reset

Next, power on the cube again, as we detailed in step 1 above.

Note that after a factory reset, this speaker comes up in pairing mode. The Status lamp blinks white rapidly to announce this. This is a signal for you to look for this speaker on a nearby BT device, and pair to it if you so desire.

4. Done with Sony Cube Speaker Factory Reset Instructions !

Factory reset is now done. So you may now sell or gift the cube, or pair it again with your favorite Bluetooth devices.

After a factory reset, the speaker no longer automatically connects with any previously paired Bluetooth device. Thus, to restore this auto pairing, you manually pair the cube with a device. Then any time that both speaker and that device have Bluetooth turned on, and they’re in range of one another, pairing automatically takes place once more.