The Sony XB23 has a simple battery level indicator LED on the button panel, just beneath the Power button, as shown in the pictures that follow. This tells battery status. E.g. Whether it’s draining or charging, or whether it’s critically low or not when discharging. But it neither reads out charging progress, nor precisely how full the battery is at a given time. But it does blink orange when the battery hits close-to-dead status. So in this post, we explain how to read this battery indicator LED on the XB23 speaker.
note that to obtain a more precise reading of battery percentage, see below.
The battery indicator lamp is OFF in the following scenarios:
With the charger unplugged, the XB23 powered ON, and the battery having very low power left, this LED starts flashing orange. The meaning here is that the speaker will shorty switch off due to a dying battery, and so, you should put it on the charge soon to avoid play interruption.
[display_google_ad]
This orange LED also lights steadily (no blinking) as the XB23 recharges, as we see in the next picture. On this speaker, the light glowing is the only visual way of telling that charging is happening. But it does not show how far along the recharging is, until the light actually turns OFF.
Also note that this light should never blink on and off while charging the speaker. If it does, then either your charger is not supplying enough (or any) power, your USB cable is defective, or you have some issue inside the speaker itself.
As speaker charging progresses, the light keeps glowing, But after a few hours, battery recharging finishes, and the lamp goes OFF to show this. It is dark in this case whether the speaker itself is ON or OFF. Note that the light will go dark too, if you disconnect the charger before the charge cycle has finished.
When unplugged from the charger, this light becomes the battery charge left indicator. Well sort of. I.e. If it is dark when the speaker is ON, then the battery has some amount of play time left, although you cannot tell how much. If it flashes, then you can infer that the battery is almost dead.
However, on this speaker, you can get a more precise reading on the percentage of battery charge left.
Just press and release the BATT button on the side button panel. This makes the speaker announce the remaining power percent value in a female voice.
This post explains How to Setup Honeywell WiFi Thermostat for one of their touchscreen full…
This post gives the Setup Honeywell Thermostat WiFi procedure for one of their touchscreen full…
Fast acting. Low odor. Economical. Low skin irritation. Hard to rinse. These phrases describe Lysol…
Fast acting. Low odor. Economical. Low skin irritation. Hard to rinse. These phrases describe Lysol…
Fast acting. Low odor. Economical. Low skin irritation. Hard to rinse. These phrases describe Lysol…
Why would you need to know this Find MAC Address on Honeywell Thermostat procedure? It…