An iPhone beside the Harman Kardon Invoke Bluetooth speaker.
Tis post shows how to connect common Harman Kardon speakers to iPhone.
Using the Invoke speaker for this demo, we note that this unit has no Power button. In fact, it has no batteries, and runs exclusively on AC power. So to power it up, you just plug it in.
At the lock screen, swipe up from the bottom. This to bring up the phone’s Home screen, or press the Home button if your phone is older.
We found ours on the second page of the home screen, shown next.
Tap the Settings app icon.
The phone then displays the first page of its settings, as we see.
Tap the Bluetooth item. Our Bluetooth screen then displays.
Note that our Bluetooth is active here. If yours shows as OFF, then move the switch item to ON.
But pairing mode is not active on our test Harman Kardon speaker. So it does not show up in the Bluetooth devices list. Also, we don’t see it since we’ve never paired this speaker with this iPhone before.
Now if you haven’t done this already, plug your speaker into AC power. It then boots and the light on the top glows in various patterns.
The speaker then powers up and makes some sort of power-on sound after about a minute. Then the light island goes dark and the speaker is now ready to accept incoming pairing requests from source devices.
But since the iPhone does not know about this speaker, the phone will not pair with it automatically. The Pairing button denotes this not-paired state by either remaining dark, or by flashing.
Now to see your speaker on your mobile device, place it into pairing mode. To do that, press and release the Pairing button. In this demo, find this button on the back near the bottom of the speaker.
Thee speaker then plays another, but different, rising notes sound, and the Pairing button starts fast blinking white.
See the screen shot next.
Tap the listed speaker in the Other Devices section of the BT devices list.
Your iPhone then connects with the speaker (named “HK Invoke_C33656” in this scenario). The mobile device’s Bluetooth screen then changes to look something like the following.
Typical Harman Kardon speakers play some notes now. Why? Because this tells that pairing mode is active, and that we can now attempt to pair.
At last, we have a successful link with this BT speaker. Likewise, similar routines work with pairing iPod Touch players, iPad Pros, and iPhones. And finally, pairing with Android devices works like this too.
Here we cover the Amazon Echo Dot 3rd generation power cable specs. This is the…
The Sony SRS XB32 speaker charging indicator is a small LED light in the back…
Here we cover the Echo Dot 3rd generation power adapter specs. This is the wall…
You must know how to set the Echo speaker to pairing mode to connect it…
The JBL Go 2 speaker by Harman Kardon is a low power, hand-held style unit…
Shows how to fix Honeywell wireless thermostat connection failure issues. You might see these on…