This piece covers how to charge the Sony SRS XB01. Do this easily through the micro USB power in port, shown in the pictures below. Note that you can still play your XB01 as it charges, without increasing the recharge time by very much.
First, pick a strong enough USB power adapter, as no charger comes with the Sony SRS XB01. Next, connect a medium current USB cable (one that easily handles 1.0 amps) between the speaker and that adapter (the speaker comes with a short micro USB to USB-A cord). Then, plug the charger into a working wall outlet. Finally, after three hours or so, your XB01 finishes recharging. So it’s ready to play once more for up to six (6) hours before needing another recharge.
The charger you use should provide 5 volts and at least 0.5 amps (2.5 watts). So here, we use the Key Power model HDD15-3-PD USB charging station. Now as mentioned, this speaker needs roughly a half an amp of current to recharge fully in the shortest time. So this charger supplies way more than enough capacity to do the job.
Note that the SRSXB01 still charges when powered ON. But depending on how much above-and-beyond recharging headroom that your charger supplies, the speaker might charge a little faster when turned OFF.
First, open the water resistant port door.
Then, plug the small end of the cable into the port on the back of the speaker, as we see in the next shot.
Next, connect the large end of the cord to the AC or car adapter.
Now that we connected the XB01 and our adapter, we then plug the mains end of the adapter into a working AC outlet, as we show next. We plugged ours into a surge protecting power strip.
The status lamp lights up solid orange on the speaker. And while no battery status gauge shows percentage of charge, the glowing CHARGE lamp means that charging is occurring, as shown next.
Full battery charging is complete when the solid glowing status lamp on the top front of the speaker turns off, as shown next.
Also, close the port cap to maintain water resistance.
We have now fully charged this wireless speaker.
Finally, repeat this recharging every twelve hours of play, to keep the battery in top condition for years.
Here, we show how to factory reset the Chromecast receiver. First, a factory reset restores…
Here, we offer our Chromecast Audio Factory Reset procedure. Doing this restores this unit to…
The Google Chromecast Audio receiver now offers basic equalizer controls (bass and treble). Moreover, you…
The Google Chromecast Audio offers basic equalizer controls (bass and treble). Moreover, you set these…
Gives the Connect Google Chromecast Audio Directions. These explain how to plug in to its…
Here, we explain How to Put Sony SRS XB22 in Pairing Mode. You need to…