How to Put Sony X 2 in Pairing Mode

The Sony SRS X2 speaker showing as discovered on iPadOS.

To pair your X 2 Sony speaker with a Bluetooth source device for the first time, or to refresh old connection info in that device, you have to know how to start up discovery mode on the speaker. Moreover, in this mode, the speaker broadcasts its name and currently valid connection information over the Bluetooth airwaves, and this allows other devices to pair to it. So in this post, we show you how to put the Sony X 2 into pairing mode, to let you to link it with phones, tablets, computers, and smart speakers and enjoy better sound.

How to Put Sony X 2 in Pairing Mode, Step by Step

1. Turn On the Speaker

Turn on the speaker by rapidly pressing its Power button.

E.g. See this button, that we point out with the green arrow, in the next picture.

The Power button on the Sony X 2.

The speaker then comes on.

The green glowing Power light.

2. Press and Hold the Pairing Button for Two to Three Seconds

Secondly, place the unit into pairing mode by pressing and holding the the Pairing button, as pointed out next.

The Pairing button.

When you press this button, the speaker beeps twice. Plus, the Pairing lamp begins rapidly flashing white.

The Pairing light on the Sony X 2 blinking white.

3. Done with How to Put Sony X 2 in Pairing Mode

While the Pairing light is blinking, you should be able to see the X 2 on any in-range phone, computer, tablet, or smart speaker, that is within several feet of it, as shown next.

The speaker showing as discovered on iPadOS.

Finally, note in the last picture, that the speaker appears as “SONY:SRS-X2”. So at this point, you could connect to this speaker if you wish.