How to Restart JBL Go 3 Bluetooth Speaker

Top front right view of the JBL Go 3 BT speaker.

We show here How to Restart JBL Go 3 Bluetooth Speaker, to restore it to its default factory settings. Plus, it erases any earlier paired Bluetooth devices from the speaker’s memory. Removing these stops the speaker from pairing to any nearby Bluetooth devices after the restart. Also, you might restart to make it ready or sale or re-gifting, or to stop the auto pairing with devices you no longer wish it to pair with when you turn it on.

How to Restart JBL Go 3 Bluetooth Speaker: Step by Step

1. Turn on the Speaker

Press and hold the Power button until the status lamp on the right ide lights up and the guitar strum sound plays.

The right side view of the JBL Go 3 Bluetooth speaker. Showing the -Power- button.

Find the Power button, as shown in the last picture above.

Then, the status light comes on, as shown next.

The -Status- light glowing.

2. Wait for the Power Up Guitar Sound

The speaker makes a rising electric guitar strum sound when it powers up. The JBL Go 3 is ready for use after this sound stops.

Now it may or may not pair with a device, depending on whether there are any in-range Bluetooth devices that know about the Go 3. But whether paired or not, the restart works the same way, as follows.

3. Press the Volume UP and Bluetooth Buttons Together to Continue with How to Restart JBL Go 3 Bluetooth Speaker

Find the Bluetooth and Volume UP buttons. The BT button is on the right side panel, second button down from the top of the speaker. The Volume UP button is on the top, nearest to the right edge of the speaker. We pointed blue arrows at both buttons in the next picture.

The -Volume UP- and -Bluetooth- buttons on the JBL Go 3 Bluetooth speaker.

The JBL Go 3 then begins the restart operation.

Then, within a second or two, the unit powers off after restart finishes, the falling guitar strum sounds, and after the status lamp goes dark, as shown next.

The dark status lamp.

4. Check that the Restart of the Speaker Did Indeed Work

Next, power on the speaker again, as explained in step 1 above.

Note that after restart, the speaker comes up in ready-to-pair mode, with the status lamp rapidly flashing white.

5. Done with How to Restart JBL Go 3 Bluetooth Speaker !

Restart of the JBL Go 3 Bluetooth speaker is now done. So you may gift or sell it, or pair it again with your favorite Bluetooth devices.

Now after restart, this speaker no longer automatically connects with any previously paired Bluetooth device that happens to be in range and in Bluetooth pairing mode. Thus, to restore automatic Bluetooth pairing, you would manually pair the Go 3 with a desired device. Then after that, any time that both this speaker, and that device have Bluetooth turned on, pairing would automatically take place again.