We show you here how to reset a JBL Go 3 Bluetooth speaker, to restore it to its default factory settings. Resetting returns this unit to factory default state. Plus, a full reset clears any earlier paired Bluetooth devices from the speaker’s memory. Erasing these stops this speaker from pairing to any nearby Bluetooth devices after the reset.
Further, you might reset to make it ready or sale or re-gifting, or to stop it from pairing with devices you no longer wish it to pair with whenever you turn it on.
How to Reset JBL Go 3 Bluetooth Speaker
1. Turn on the Speaker
First, press and hold the Power button until the status lamp on the right side lights up and the guitar strum sound plays.
To turn on the speaker. find and briefly press for a half second and then release the Power button, as shown in the last picture above.
Then, the status light comes on, as shown next.
2. Wait for the Power Up Guitar Sound to Complete
The speaker makes a rising electric guitar strum sound when it powers up. The JBL Go 3 Bluetooth speaker is ready for use after this sound finishes.
Now at this time, the Go 3 may or may not pair with a device, depending on whether there are any in-range Bluetooth devices that know about this speaker But whether paired or not, the reset works the same way, as described below.
3. Press the Volume UP and Bluetooth Buttons Together
Next, find the Bluetooth and UP Volume buttons. The BT button is on the right side panel, beside the Power button. We also find the Volume UP button on the top panel of the unit to the right. We highlighted both buttons with the blue arrows in the following picture.
The speaker then enters reset. Within ten to twenty seconds, the unit powers off after reset finishes, the falling guitar strum sounds, and after that, the status lamp goes dark, as shown next.
4. Check that the Reset of the JBL Go 3 Bluetooth Speaker Did Indeed Work
Next, power on the speaker again, as described in step 1 above.
Note that after reset, our speaker came up in ready-to-pair mode, with the status lamp rapidly flashing white.
5. Done with How to Reset JBL Go 3 Bluetooth Speaker !
Finally, the reset of the speaker is now done. So you may now gift or sell it, or pair it again with your favorite Bluetooth devices.
After reset, this device no longer automatically pairs with any previously paired Bluetooth device that happens to be in range and in Bluetooth pairing mode. So, to restore auto-pairing, you manually pair the Go 3 with a desired device. Then after that, any time that both this speaker, and that device have Bluetooth turned on, pairing would automatically take place again.
Other Posts About the JBL Go 3 Bluetooth Speaker
Related Posts
References for How to Reset JBL Go 3 Bluetooth Speaker
Revision History
-
- 2021-07-05: First posted.