JBL Boombox 1 Extra Bass Mode

Change how much rumble you get on the JBL Boombox 1, by turning on and off its extra bass mode. When ON, this mode makes the passive bass radiators vibrate much more. Plus it adds a low rumble quality to the playing program, that carries pretty far from the speaker.

JBL Boombox 1 Extra Bass Mode: How to Turn OFF

By default, the JBL Boombox 1 has its bass mode turned on after a factory reset.  This adds a bit of treble and lots of extra bass to the sound.

You can turn this Extra Bass mode off by pressing the Volume Down (-) and Bluetooth buttons. Then hold them in for about ten seconds.

Hold until the Power and Connect buttons light up together.  Find all these buttons on the top of the speaker.

JBL Boombox 1 Extra Bass Mode: How to Turn ON

To turn Extra Bass mode back on, then again, press the Volume Down and Bluetooth buttons. Hold them in until the Power and Connect buttons light up.  Then release them.  When the buttons inside the oval island light up, the Extra Bass mode resumes once more.

Warning

The drivers really rock when you activate this mode.  So use caution in how loudly you play this speaker when LFM is active. Doing so avoids damage to the speaker drivers inside. So if the bass is crackling, tapping, or otherwise distorting, turn it down !

Other Posts About the JBL Boombox 1

1. 1. Firmware Update Instructions
   2. JBL Boombox 1 Buttons Explained
   3. How to Put in Pairing Mode
   4. How to Bass Boost
   5. Hard Reset Instructions

References

1. 1. JBL Boombox 1 Official Product Page
   2. Where to Buy the JBL Boombox 1