Reset Wonderboom Speaker

Front view of the Wonderboom 1.

Here, we demonstrate the Reset Wonderboom Speaker procedure. This return the unit to its default settings.

Resetting wipes any paired Bluetooth devices from memory. Clearing this data prevents the speaker from connecting to any nearby BT devices afterwards. Further, you might reset to ready the unit for sale or re-gifting. Or, perhaps you simply wish to stop it from pairing with devices you no longer listen to.

Reset Wonderboom Speaker: Step by Step

1. Turn on the Speaker

Press and release the Power button. The status lamp in that button lights and you hear a power-up sound. We circled the Power button in the next picture.

The Wonderboom speaker top view. Showing the dark -Power- button.

Then, the status light comes on solid or it blinks, as shown next.

The glowing -Power- button.

2. Wait for the Power Up Sound

The speaker makes a unique electronic sounding noise when it turns on. The speaker is then ready for use when this sound stops.

Now it may or may not pair with a device. That depends on whether you have any in-range Bluetooth devices that know about the Wonderboom. Whether paired or not, the reset works as follows.

3. Unpair the Speaker Before Reset

This speaker does not answer to the reset command while connected with a source Bluetooth device. So disconnect it before resetting.

4. Press the Power and the Volume DOWN Button Together for Five to Eight Seconds

Find the Power and Volume DOWN buttons. The Power button is on the top of the Wonderboom, near the front. Volume DOWN is the long plum line on the front, near the bottom. See these both pointed out by the green arrows in the next picture.

The -Power- and -Volume DOWN- buttons.

The speaker then enters reset. Within a couple seconds, the unit switches off afterwards. Then the falling electronic ker-plunk sound plays. Then the status lamp in the Power button goes dark, as shown next.

The dark -Power- button.