This piece gives Sony XB 23 charging instructions. Recharge this speaker easily through the USB-C power in port, behind the water resistant door near the bottom of the unit, just below the buttons panel, as shown in the pictures below. Note that you can still play your XB 23 cylinder speaker during charging, without adding to the recharge time too much, especially if you are using a full-current USB charger.
First, the unit comes with a suitable USB-A to USB-C charger cable. But you must provide a strong enough USB adapter with a USB-A female connector, to plug that cord into. This particular speaker requires about 7.5 watts (5 volts at 1.5 amps max). Thus any full-current USB 2.0 power supply should work nicely here.
At any rate, once you choose the charger you will use, plug it into a working AC outlet.
Then after four hours, your XB 23 finishes charging. So it’s ready to play once more for up to twelve (12) hours before needing another recharge.
The charging adapter should, as mentioned above, offer 5 volts at 1.5 amps (7.5 watts) available power, at least. So here, we use the Key Power model HDD15-3-PD USB power delivery system along with a thick USB supply cable.
Use a fingernail, dime, penny, or small screwdriver to pry open the waterproof seal port cover on the XB 23.
See the opened power port compartment in the next picture. Be careful not to scratch the delicate seal around the inside edge of this door.
Prying open this door exposes the USB charging port inside, as shown in the last picture, pointed at by the green arrow.
Note that the XB 23 still charges when powered ON. But depending on how much above-and-beyond recharging amperage your charger provides, the speaker might recharge somewhat faster when not running. It will certainly charge faster when you’re not playing it at louder volumes.
Then, plug the matching end of your charging cable into the port, as we see in the next shot.
If the supply you use has a removable cord, then be sure to connect the matching end of the USB power cable to the AC or car adapter you have.
Now that we connected the XB 23 and our adapter, we then plugged the mains end of the supply box into a working AC outlet, as shown next. We plugged ours into a surge protecting power strip.
The CHARGE lamp then lights up solid orange on the speaker. And while no battery status gauge shows percentage of charge, the glowing lamp means that charging is indeed occurring, as we see next.
Full battery charging wraps up when the CHARGE lamp turns off, as shown next.
Note that unless you seat the port cap correctly, water may flow into its power in / out ports. And, since water and electronics do not work well together, getting those connections wet might deteriorate the delicate contacts inside. So be certain to press this door closed with enough force to fully seat it, for maximum moisture protection.
See the properly closed port door in the last picture.
We have now fully charged our XB 23 speaker.
Finally, repeat this recharging every (up to) twelve hours of play, to keep the battery in top condition for years to come.
Here, we show how to update JBL Charge 3 speaker firmware for this popular Bluetooth…
We received the Waterpik NSP-853 Power Spray Plus massaging shower head for Christmas some years…
All smart speakers in the Google Home family now support Bluetooth. They can act as…
Firstly, the original Google Home speaker has a sleep timer that you can set and…
Follow these JBL Flip 4 speaker charging instructions for longest play using the hidden USB…
Here, we list JBL Flip 4 speaker specs specifications. To summarize, these cover the speaker's…