The Sony SRS XB32 speaker -CHARGE- light glowing orange.
This piece covers how to charge Sony Bluetooth speaker – typical models. Do this easily through the USB or barrel power in port. Any Sony speaker has one somewhere. The water resistant models have it behind a flexible sealing door, shown in the pictures below. Note that you can still play your speaker speaker as it charges, without lengthening the recharge time very much.
First, many Sony Bluetooth speaker models come with a suitable charger. So use the one that accompanies the speaker if you can, for best results. But if you lose yours, then pick a strong enough adapter. In this example, we use the Sony SRS XB43 Bluetooth speaker. Furthermore, this particular model requires 15 watts (5 volts at 3 amps max).
Then, once you’ve chosen the correct charger, plug that into a working AC outlet. Finally, plug the DC end into the speaker.
Finally, after four to six hours, your speaker finishes charging. So it’s ready to play once more. The play time varies among the different speaker models. But it ranges from 10 to 24 hours roughly.
The charger you use should provide 5 volts and at 3 amps (15 watts). Here, we use the adapter that Sony includes with this speaker. However, a Key Power model HDD15-3-PD USB power delivery system along with a thicker USB-C cable also works well.
Use a fingernail, dime, penny, or small screwdriver to work open the waterproof seal port cover if yours has this. Be careful though not to scratch the delicate seal around the inside edge of this door.
Prying open this door exposes the charging port inside, as shown next, pointed at by the red arrow.
Note that most Sony Bluetooth speakers still charge while running. But the speaker might charge a bit faster when turned OFF. This depends on how much above-and-beyond recharging juice your power supply offers.
Then, plug the matching end of a USB-C charge cable into the port, as seen in the next shot.
Warning: Only use the correct port for charging the speaker. On Sony Bluetooth speakers that have this, do not use the output port. This is for power bank function only, to power other devices. In this example, feeding external power into THIS port will not only fail to recharge the battery. But it could also damage the electronics inside.
Now the supply you’re using perhaps has a detachable cable. If so, then make sure to connect the matching end of the power cable to the charger you have. Note though that the included adapter with the Bluetooth speaker here has a permanently attached cord. So skip this step if that’s the sort of cable you have.
Connect the mains end of the adapter into a working AC outlet. Here, we plug ours into a surge protecting power strip.
The status lamp lights up solid orange. Now there usually is no battery status gauge that shows percentage of charge. Still though, the glowing lamp means that charging is underway. You just can’t tell visually how far along it actually is.
Full battery charging is complete when the CHARGE lamp shuts off.
Now be sure to seat the port cap securely. If not, then water may soak the power input port. And, since water and electronics generally do not mix, this might damage the sensitive contacts inside. So press this door firmly closed for the best moisture protection.
We have now fully charged our speaker.
Finally, repeat this recharging whenever the speaker runs dead, to keep the battery in top condition for years to come. But do not allow the battery to sit, in a deadened state for long, as this could shorten its life.
The JBL Go 2 speaker by Harman Kardon is a low power, hand-held style unit…
Shows how to fix Honeywell wireless thermostat connection failure issues. You might see these on…
Shows how to connect HP DeskJet 3630 series to WiFi. Note that doing this will…
Here, we show how to reset the Wonderboom speaker version 2. which returns it to…
We give here the JBL Clip reset directions, that return it to its default settings…
The JBL Boom Box JBL by Harman Kardon is a moderate to higher power, boom…